Santec VOGUE 6565VO Series, VOGUE 6565VO10 Instruction Booklet
VOGUE COLLECTION
PAPER HOLDER
MODEL: 6565VO10
6565VO__
PARTS BREAKDOWN
3
Ø2
"
8
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
Important : Please register your product online at www.santecfaucet.com within
30 days of purchase. Santec reserves the right to request additional documents
before servicing warranty requests.
01
#
DESCRIPTION
1
Paper Holder Post- Left *
2
Paper Holder Post- Right *
3
Accessories Bell *
#10-24 Set Screw PM-027
4
5
Flange * P00076
* Please specify the nish when ordering the part.
PART #
PA-2925L
PA-2925R
PA-2200
#
DESCRIPTION
6
Mounting Post
7
Screws
Toggle
8
Allen Key PM-033
9
Spring PA-2900
10
Rubber Washer PM-400
11
PART #
PM-960
PM-016
PM-026
02
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
Place the trim parts against the assigned wall location. Make sure that the roller is leveled and the roller
1.
post positions are correct. Leave 5” to 5-1/4” space between the roller posts for the rollers. Mark the
roller post ange positions and remove the trims.
5” ~ 5 ”
1
4
WALL
Using the mounting hardware position as a reference, mark the screw hole positions in the center of the
2.
post ange mark on the wall.
INSTALLING ON WOODEN SURFACE
For wooden surface, the mounting posts can be
secured by screwing the screws directly into the wall.
Using the Allen key provided, loosen the roller posts’ set screws. Slip the left roller post onto the left
3.
mounting hardware post. Align the roller post and secure it by tightening the set screw.
Insert the rollers with the spring onto the secured roller post. Slip the right roller post onto the right
4.
mounting hardware post. Insert the right side of the rollers into the right roller post. Align the roller post
and tighten the set screw rmly.
Check both roller posts to make sure they are rmly secured. If not, tighten the set screws with the
5.
Allen key.
INSTALLING ONTO DRYWALL SURFACE
Using a drill, pre-drill holes for the anchors. Insert the
anchors into the wall. The mounting posts can be
secured by screwing the screws into the anchors.
INSTALLING ONTO A SOLID SURFACE
Measure the dimensions carefully. Using a drill,
pre-drill the holes. Secure the mounting posts by
screwing the screws into the wall.
03
04
Loading...