Santec SA2WAY12 User Manual

ESTATE SERIES
2-Way Diverter
MODEL NUMBER
SA2WAY12
Out
Out
IN
1/2”-NPT
INSPECTED BY
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
PAGE 01
MODEL NUMBER
SA2WAY12
Shower Head
1. Using 1/2" IPS, plumb the Diverter valve accordingly to the handle styles described below. (Measurement is from the center of water connection
Out to Shower Head
to outside of finished wall).
2. Allow 1 3/4" diameter hole for the valve stems.
Out
In
1/2”-NPT
Out to Hand Shower
Out
Supply Elbow Required
3. Allow a 1 1/4" diameter hole for the shower arm or personal shower elbow.
WARNING: Where tile construction is planned for the finished walls, allow for extra thickness dimensions when roughing the valve.
From Control Unit
Off
SANTEC
On
TEST FOR PROPER FUNCTION BEFORE CLOSING WALLS!
5. Apply the finish trim.
INSTALLATION
Failure to follow these instructions may cause damage or improper operations and nullify the warranty.
NOTE:
6.5”
ROUGH IN
.
1.75
finished wall
center of inlet
PAGE 02
Loading...
+ 1 hidden pages