Santec 9955CR User Manual

PLEASE READ THE INSTRUCTIONS COMPLETELY
BEFORE BEGINNING THE INSTALLATION.

COLLECTION

R OMAN T UB S
WIT H HANDHE LD

This is a general installation instruction
for the following collections:
* AVA
* AVA CRYSTAL

MINIMUM HOLE SIZE FOR THE SPOUT

AND HANDLE TRIM IS 1

MAXIMUM OF 1

¼” AND

½”

*** NOTE: SHUT OFF WATER SUPPLY BEFORE BEGINNING INSTALLATION***

INSPECTED BY

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

S POUT INSTALLATION

FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION.
AFTER FLUSHING, SHUT OFF BOTH SUPPLY LINES.

MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1-1/4”
AND MAXIMUM IS 1-1/2”

1. Remove the tee connector and spout mounting hardware from
quick connect shank being sure to leave on brass plate.

2. Apply a ring of silicone caulking

around hole designated for spout.

DO NOT USE PLUMBERS’ PUTTY, WHICH CAN DAMAGE FINISH.

3. From the top of the deck, slip the quick connect shank through
the assig ned spout hole.

4. Secure the quick connect shank by putting

the washer and lock nut

back on the shank. Tighten the lock nut rmly.

5. From the top of the deck, slip the spout with the ange and ange
washer onto the quick connect shank top. Al ign the spout and tighten
the set screw with the Allen key provided.

6. Connect the tee connector to the spout shank.

S ILI CO NE

COLLECTION

ROMAN TUB WITH HAND HELD