Santec 9001P2 User Manual

COMPLETE BOTTLE P-TRAPCOMPLETE BOTTLE P-TRAP

ITEM NUMBER

9001P2 __ - __

2

1

3

4

Part Description# Part #

Lock nut for bottle P Trap

1

Cardboard Washer, Lock Nut

2

Nylon Sleeve, P-trap

3

Wall Flange

4

P-Trap

5

Bottom Cap

6

Horizontal Tube

7

Rubber Washer for Horizontal Tube

8

* Please Specify the finish when you order this part

7

8

KB291-6
VA-101
VA-103
KB-291-1
KB-291-4
KB-291-3
KB-291-2
VA-104

2 ¾”

12”

6

1”

5

5¼”

2” (diameter)

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

INSTALLATION PROCEDURE
(1)

- Take out the Lock Nut, washer and Nylon Sleeve from
the bottle P trap.

- Slide Locknut, washer and Nylon Sleeve on the drain
pipe as shown in the figure.(Sliding direction is shown by
the upward arrow)

- Drain pipe with Nylon sleeve to be inserted into the bottle
trap as shown by the downward arrow.

9001P2_ _

Lock Nut

Washer

Nylon Sleeve

Nut for Horizontal Tube

Wall Flange

(2)

- Insert pop-up drain tube with plastic sleeve
into the bottle P trap unit and hand
tight the lock nut.

- Slide the nut on the horizontal tube.
Slide on the rubber washer on the horizontal tube.

- Hand tight the nut to secure the horizontal tube with
bottle P trap.

- Wall flange goes against the wall.

- Connect the horizontal tube to the
drain pipe through the wall.

Bottle P-Trap

Rubber Washer

Dia. 1 & ¼ Inch

l
al
W

PAGE 02