Santec 8867NU User Manual

REVERE COLLECTION
TOOTHBRUSH/ TUMBLER HOLDER

TOOTHBRUSH/ TUMBLER HOLDER

ITEM NUMBER

8867NU _ _-_ _

MOUNTING HARDWARE POST

MOUNTING SCREWS (2)

DRY WALL TOGGLES(2)

ALLEN KEY

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

1- Take the toothbrush/ tumbler holder off the box.
Place the holder against the assigned wall location.
Mark the holder’s flange position and remove the trim.

8867NU _ _

2- Using the mounting hardware post as reference, mark the screw hole positions
in the center of the flange mark on the wall.

2a- INSTALLING ON WOODEN SURFACE

- For wooden surface, the mounting hardware post can be secured by
screwing the screws directly into the wall.

2b- IF INSTALLING ON A DRYWALL

- Using a drill, pre-drill holes for the toggles.

- Fold the toggle’s leg and insert it into the wall.

- The mounting hardware post can be secured by screwing the screws
into the toggles.

2c- IF INSTALLING ON A SOLID/HARD SURFACE

- Measure the dimension carefully.

- Using a drill, pre-drill the holes.

- Secure the mounting hardware post by screwing the screws into
the wall.

3- Using the Allen key provided, loosen the holder’s set screw.
Slip the holder onto the mounting hardware post.
Adjust the holder to make sure the holder’s dish is horizontally leveled.
Tighten the set screw after the adjustment.

WOODEN SURFACE

DRY WALL SURFACE

HARD SURFACE

4- Check the holder to make sure it is firmly secured.
If not, tighten the set screw with the Allen key.

Santec Inc.

3501 Challenger Street, Torrance, CA 90503
Tel: [phone] Fax [phone]
www.santecfaucet.com

05/03

PAGE 02