Santec 8866NU User Manual

REVERE COLLECTION
ROBE HOOK

ITEM NUMBER

8866NU _ _-_ _

ROBE HOOK

MOUNTING HARDWARE POST

MOUNTING SCREWS (2)

DRY WALL TOGGLES(2)

ALLEN KEY

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

1- Take the robe hook off the box.
Place the robe hook against the assigned wall location.
Mark the robe hook flange position and remove the trim.

8866NU _ _

2- Using the mounting hardware post as reference, mark the screw hole positions
in the center of the flange mark on the wall.

2a- INSTALLING ON WOODEN SURFACE

- For wooden surface, the mounting hardware post can be secured by
screwing the screws directly into the wall.

2b- IF INSTALLING ON A DRYWALL

- Using a drill, pre-drill holes for the toggles.

- Fold the toggle’s leg and insert it into the wall.

- The mounting hardware post can be secured by screwing the screws
into the toggles.

2c- IF INSTALLING ON A SOLID/HARD SURFACE

- Measure the dimension carefully.

- Using a drill, pre-drill the holes.

- Secure the mounting hardware post by screwing the screws into
the wall.

3- Using the Allen key provided, loosen the robe hook’s set screw.
Slip the robe hook onto the mounting hardware post and tighten
the set screw.

WOODEN SURFACE

DRY WALL SURFACE

HARD SURFACE

4- Check the robe hook to make sure it is firmly secured.
If not, tighten the set screw with the Allen key.

Santec Inc.

3501 Challenger Street, Torrance, CA 90503
Tel: [phone] Fax [phone]
www.santecfaucet.com

05/03

PAGE 02