Santec 8463PU User Manual

GRAND/ KORUM/ KRISS COLLECTION
TOWEL RACK

COMPLETE TOWEL RACK UNIT

ITEM NUMBER

8463PU _ _-_ _

MOUNTING HARDWARE POST

MOUNTING SCREWS (2)

DRY WALL TOGGLES(2)

ALLEN KEY

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

1- Take the pre-assembled towel rack unit off the box.
Place the unit against the assigned wall location.
Make sure that the rack bar is leveled and the bar post position is correct.
Mark the bar post flange position and remove the unit.

8463PU _ _

WALL

2- Using the mounting hardware post as reference, mark the screw hole positions
in the center of the post flange mark on the wall.

2a- INSTALLING ON WOODEN SURFACE

- For wooden surface, the mounting hardware posts can be secured by
screwing the screws directly into the wall.

2b- IF INSTALLING ON A DRYWALL

- Using a drill, pre-drill holes for the toggles.

- Fold the toggle’s leg and insert it into the wall.

- The mounting hardware posts can be secured by screwing the screws
into the toggles.

2c- IF INSTALLING ON A SOLID/HARD SURFACE

- Measure the dimensions carefully.

- Using a drill, pre-drill the holes.

- Secure the mounting hardware posts by screwing the screws into
the wall.

3- Using the Allen key provided, loosen the rack post’s set screw.
Slip the rack post onto the mounting hardware post.
Secure the set screw by tightening the set screw with the Allen key.

WOODEN SURFACE

DRY WALL SURFACE

HARD SURFACE

4- Check the rack post to make sure it is firmly secured.
If not, tighten again the set screw with the Allen key.

Santec Inc.

3501 Challenger Street, Torrance, CA 90503
Tel: [phone] Fax [phone]
www.santecfaucet.com

05/03

PAGE 02