Santec 7093KT-TM User Manual
KLASSICA COLLECTION
MODEL: 7093KL-TM
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
Important : Please register your product online at www.santecfaucet.com within
30 days of purchase. Santec reserves the right to request additional documents
before servicing warranty requests.
0 1
MODEL: 7093KR-TM
MODEL: 7093KT-TM
3/4” THERMOSTATIC
02
7093KL, KR, KT _ _
Top Outlet
Temperature Limiter
Service/
Check Stops
Control Spindle
Cover
Plastic Mud
Guard
TOP - VIEW
TOP - VIEW
Hot Inlet
3/4” NPT
Cold Inlet
3/4” NPT
MAXIMUM HOL E CUT-OUT IN
FIN ISHED WALL = 4-7/8” x 3”
Diagram B
Diagram A
2”
to
2-3/8”
A
1-5/8”
to
2”
B
Fi n ishe d Wall
PART #00 4275
1-3/4”
to
2-3/8
C
03
7093KL, KR, KT _ _
R oug h
WARNI N G: FA IL URE TO F O LLOW THESE I NSTRUC TI ONS, OR IMP ROPER
OP E RATION, MAY DAMAG E THE VALVE AND VOI D THE WARRANTY.
IMPORTANT: Do not remove the con trol sp indle cover un til i nstructed.
Accidenta lly tur ning the control spind le will change the tem peratur e
setting, wh ich is pre-callibrated from the factor y.
Remove the large plasti c mud guard from valve. DO NO T discard
plastic mud gua rd.
Insta ll the tub plu g into t he bottom o utlet. Le ave it unplu gged if
including a tub spout. For deta ils and diagra ms of different
showe r/tub sc hemes, see the Installation Options section.
IMPORTANT: DO NOT SOLDER DIRECT LY TO THE VALVE. THI S WILL
DAMAGE THE SERVICE/CHE CK STOPS AND THE TEMPE RAT URE
CONTRO L ELE MENT. USE TEFLON TAPE OR PLU MBER’S PIPE
COMPOUND TO SECURE ALL CONNECTIO NS TO THE VALVE.
Connect the HOT w ater supply to the left inlet of the valv e (RED) and
COLD supply to the right inlet of the valve (BLUE). See Diagram A.
Secure valve position in the wall usi ng min/max ad justment lim its. For
backse t measurements see Diagram B.
Connect the top outle t pipe to shower connec tions and bottom outlet
pipe to tub spout (de pending on the s hower/tub sch eme chosen).
Remove the plastic control
spin dle cover and i nstall the Temper ature
Lim iter with the “red mark” positioned e xactly at 12 o’c lock.
Rememb er to n ot tur n the control spindle while installing the
Temperature Limiter.
Re-in stall the large plastic mud guard back onto the valve and do not
remove it until trim arrives.
04
7093KL, KR, KT _ _
Tr i m
Parts Breakdown
Finished Wall
1
2
8
1. Sleeve
2. Plate
3. Flange
4. Dial
5. Long Stem Scre w
6. Set Screw
7. Handle
8. Allen Wrench
3 4
5
6
7
Loading...