Santec 708460 User Manual

ITEM NUMBER

708460 __ - __

CLASSIC COLLECTIONCLASSIC COLLECTION

SLIDE BAR #6 ASSEMBLY WITH PERSONAL SHOWER #6 SLIDE BAR #6 ASSEMBLY WITH PERSONAL SHOWER #6

1

2

5

f2.2”

6

7

3

4

8

24.8”

Water Inlet

f0.7”

26.9”

f1 1/5”

Part Description# Part #

Base Body with Flange, Slide Bar *

1

Mounting Screw, Shower Slide Bar

2

Sliding Bar*

WITH CAP ON

3.43”

3

Sliding Bracket, Sub Assembly*

4

Base Cover-cap, Sliding Bar*

5

Drywall Screw, Mounting Pack

6

Mounting Post Sub Assembly*

7

Personal Hand held Shower*

8

* Please Specify the finish when you order this part

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

SL-700-6
PM-928
SL-700-1
SL-700-2
SL-800-7
PM-016
PM-927
PS-600S

PAGE 01

INSTALLATION INSTRUCTIONS

708460_ _

MARKING

1.

- Mark the vertical distance of 23 and ½ inch on the wall.

- This is the center distance between the two cylindrical holders at the
two ends of the slide bar.

- Draw two circles having their center as two marked points.

- Try to make them exact circles with defined centers, insert screws
through the four small holes in the pedestal.

- Tighten them firmly.

ASSEMBLY

1.

- Cylindrical holder for the slide bars are assembled with the bar.

- Put mounting screw through the hole in the base body.
This will go into the hole at the top of the mounting post sub
assembly.

- Firmly tighten it.

- Now slide bar and holder assembly (both ends) on the earlier
installed pedestal in such a way so that this assemble in the two
blind holes in the post.

- Align them in such a way so that mounting spindle locates
in the middle.

f 0.235”

23 ½”

ll

23 ½”

Wa

Mounting post

Hole in the post for screws

Slide bar grooved end

ll

Wa

PAGE 02