Santec 708204 User Manual

MODENA COLLECTION

ALL BRASS BODY SPRAY

ITEM NUMBER

708204 _ _-_ _

All Brass Body Spray Assembly*

Rubber Washer Flange

* Please specify the finish when ordering the part.

PART

DESCRIPTION

PART #

708204

PM-400

INSTALLATION INSTRUCTIONS

FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION

AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.

SIZE FOR WATER INLET PIPE IS 1/2”

1. Place rubber washer PM-400 in the groove of the body spray.

2. Screw in the water inlet pipe.

Water inlet pipe

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

708204_ _

1. Finishes: Santec

Limited

warranty against manufacturing defects and tarnish to the original purchaser with the

exclusion of kitchen drain assemblies which

SANTEC LIFETIME LIMITED WARRANTY

Polished Chrome, Polished Orobrass and Satin Nickel

, due to the nature of their use, are not warranted. Santec

recommended custom finishes carry a ten (10) years limited warranty against manufacturing

defects and tarnish to the original purchaser with the exclusion of kitchen and pop

assemblies which, due to the nature of their use, are not warranted.

2. Cartridges: Santec Cartridges carry a lifetime limited warranty against manufacturing defects for the life of the product to the original purchaser.

3. Parts: Santec parts carry a Ten (10) year limited warranty against manufacturing defects, to the original purchaser.

4. Warranty exclusions and limitations : This warranty does not cover: damage due to negligence, accident, abuse, improper installation, or improper maintenance such as, but not limited to: heat from soldering during installation, the use of plumbers putty, damage from tools used during installation, the use or exposure to chemicals or cleaning products either abrasive or non abrasive or the use of any cleaning tool or product other than a soft, clean cloth. This warranty does not cover: changes in the finish or in the product due to normal wear or aging and does not cover any product or parts which have been altered or used in a manner not typical for the product.

This warranty does not

cover and Santec will not be held liable for damage to products caused by the freight carrier and a claim should be made immediately to the freight carrier should this occur. This warranty

does not cover any cost involved in the installation, repair, or replace ment of any Santec product or part. This warranty does not cover and Santec will not be held liable for any loss, damages, or expenses, incidental or consequential whatsoever, originating from the purchase, installation, use, repair, failure, or replacement of any Santec product or part, as allowed by law. The product or components of the covered product will either be repaired, refinished or replaced, at the sole discretion of Santec. Santec reserves the right to examine any product claimed defective pr ior to any warranty claim being accepted or processed, at its sole discretion. This warranty gives you specific legal rights and you may have other rights which may vary from state to state.

Effective 10/01/03 - Replaces and supersedes any previously issued warranty.

finishes carry a

up drain

Lifetime

For clear coated or enamel color finishes:

We recommend that all faucets, drains, etc. be gently wiped dry with a soft cloth after use to avoid water spotting and water deposit buildup. A mild liquid hand soap, s

uch as Ivory may be used occasionally if desired. Use of a non -abrasive carnauba wax will add protection to the finish and should be used if the faucets will not be dried after

FINISH CARE INFORMATION

For non-clear coated and specialty finishes:

We recommend that all faucets, drains, etc. be gently wiped dry with a soft cloth after use to avoid water spotting and water deposit buildup. Use of a non-abrasive carnauba wax is required occasionally.

use. Santec Orobrass kitchen products are clear coated.

Santec has obtained applicable code (standards) listings generally available on a national basis for products of this type. It is the responsibility of the installer/owner to determine specific local code compliance prior to installation of the product. Santec makes no representation or warranty regarding, and will not be responsiblefor any code compliance.

Some products listed in this catalog may not be approved for use in the state of Massachusetts, check with your Local Authority or Licensed Plumber to assure code compliance.

PAGE 02