Santec 6780AR User Manual
ARKO COLLECTION
SINGLE CONTROL LAVATORY
MODEL:
K EEP THIS INSTR UCTION BOOKLE T FOR FU TUR E REFER ENCE
Important : Please register your pr oduct online at www .santecfaucet.com within
30 days of purchase. Santec r eserves the right to request additional documents
before servicin g warranty r equests.
0 1
0 2
Spout
Hole size for the spout is a minimum of 1-3/8” and a maximum of 1-7/16”.
Washer
Lock nut
6780AR10
6780AR75
6780AR97
0 3
0 4
SPOUT ASSEMBLY IS READY FOR SIMPLE DROP-IN INSTALLATION. DO NOT DISASSEMBLE.
Spout
Spout Ins tal lation Spout Ins t allat ion
Remove the washer and lock nut from the valve body.
Apply a ring of silicone caulking around the spout hole
on the sink or counter top (do not use plumber’s putty
Insert lavatory assembly through the spout hole. Make
sure to center the lavatory over hole.
A
Re-install the washer and lock nut from below.
Hand tighten lock nut from below while properly aligning
Secure from below with an adjustable wrench and
connect the inlet hoses to the supply lines. Make sure
that the hot inlet hose connects to the hot supply line,
and the cold inlet hose connects to the cold supply line.
B
C
IMPORTANT: After all the connections have been made from inlet supplies to angle stop, remove
for approximately 45 seconds to clean any debris. Turn o the water and reinsert aerator. Debris
voiding warranty.
D
Spout
Washer
Lock nut
Lift rod
Loading...