Santec 6680BO User Manual
ESTATE SERIES BRAVO COLLECTION
SINGLE CONTROL LAVATORY
Spout
MODEL: 6680BO10
6680BO75
Hole size for the spout is a minimum of 1-3/8” and a maximum of 1-7/16”.
Washer
Lock nut
15
"
16
7
"
16
3
"
8
3
4
1
"
2
1
"
4
"
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
Important : Please register your product online at www.santecfaucet.com within
30 days of purchase. Santec reserves the right to request additional documents
before servicing warranty requests.
01
02
Spout
Spout
Spout Installation Spout Installation
SPOUT ASSEMBLY IS READY FOR SIMPLE DROP-IN INSTALLATION. DO NOT DISASSEMBLE.
Remove the washer and lock nut from the valve body.
A
Apply a ring of silicone caulking around the spout hole
on the sink or counter top (do not use plumber’s putty
which can damage the nish of your faucet).
Insert lavatory assembly through the spout hole. Make
sure to center the lavatory over hole.
Re-install the washer and lock nut from below.
B
Hand tighten lock nut from below while properly aligning
the xture.
Secure from below with an adjustable wrench and
connect the inlet hoses to the supply lines. Make sure
that the hot inlet hose connects to the hot supply line,
and the cold inlet hose connects to the cold supply line.
Washer
Lock nut
Carefully t the lift rod into the back of the xture.
C
Lift rod
IMPORTANT: After all the connections have been made from inlet supplies to angle stop, remove
D
the aerator. Open the lever on the lavatory. Slowly open angle stop from below and ush the lines
for approximately 45 seconds to clean any debris. Turn off the water and reinsert aerator. Debris
present in the line will damage xture and cause leaking. Failure to ush xture could result in possibly
voiding warranty.
03
04
Loading...