Santec 6664BO User Manual
ESTATE SERIES
BRAVO/MAGGIO COLLECTION
TOWEL RING
MODEL: 6664BO10
6664BO75
Installation Instructions
Place the trim parts against the assigned wall location. Make sure that the ring is leveled. Mark the ring
1.
post ange position and remove the trim.
WALL
Using the Allen key provided, remove the mounting post from the ring post. Press the mounting post
2.
against ring post position on the wall and mark the screw hole positions.
NOTE: MAKE SURE THE ALLEN SCREW HOLE ON THE MOUNTING POST IS FACING DOWN
WHEN SECURING TO WALL.
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
Important : Please register your product online at www.santecfaucet.com within
30 days of purchase. Santec reserves the right to request additional documents
before servicing warranty requests.
INSTALLING ON WOODEN SURFACE
For wooden surface, the mounting post can be
secured by screwing the screws directly into the wall.
INSTALLING ONTO DRYWALL SURFACE
Using a drill, pre-drill holes for the anchors. Insert the
anchors into the wall. The mounting post can be
secured by screwing the screws into the anchors.
INSTALLING ONTO A SOLID SURFACE
Measure the dimensions carefully. Using a drill,
pre-drill the holes. Secure the mounting post by
screwing the screws into the wall.
ring post mark
mounting post
01
02
Installation Instructions
Press the ring post against the mounting post. Align the ring post and secure it by tightening the set
3.
screw.
Check the ring post to make sure it is rmly secured. If not, tighten the set screw with the Allen key.4.
SANTEC LIFETIME LIMITED WARRANTY
1.
Finishes: Santec Polished Chrome, Polished Nickel and Satin Nickel nishes carry a Lifetime
Limited warranty against manufacturing defects and tarnish to the original purchaser with the
exclusion of kitchen drain assemblies which, due to the nature of their use, are not warranted.
Santec recommended custom nishes carry a ten (10) years limited warranty against
manufacturing defects and tarnish to the original purchaser with the exclusion of kitchen and
pop-up drain assemblies which, due to the nature of their use, are not warranted. Kitchen
products carry a three (3) year limited warranty.
Cartridges: Santec Cartridges carry a lifetime limited warranty against manufacturing defects for
2.
the life of the product to the original purchaser.
3.
Parts: Santec parts carry a ten (10) year limited warranty against manufacturing defects, to the
original purchaser. Kitchen products carry a ve (5) year limited warranty.
Warranty exclusions and limitations: This warranty does not cover: damage due to negligence,
4.
accident, abuse, improper installation, or improper maintenance such as, but not limited to: heat
from soldering during installation, the use of plumbers putty, damage from tools used during
installation, the use or exposure to chemicals or cleaning products either abrasive or non
abrasive or the use of any cleaning tool or product other than a soft, clean cloth. Pop-up
assemblies are not covered under warranty. This warranty does not cover: changes in the nish
or in the product due to normal wear or aging and does not cover any products or parts which
have been altered or used in a manner not typical for the product. This warranty does not cover
and Santec will not be held liable for damage to products caused by the freight carrier and a
claim should be made immediately to the freight carrier should this occur. This warranty does
not cover any cost involved in the installation, repair, or replacement of any Santec product or
part. This warranty does not cover and Santec will not be held liable for any loss, damages, or
expenses, incidental or consequential whatsoever, originating from the purchase, installation,
use, repair, failure, or replacement of any Santec product or part, as allowed by law. The
product or components of the covered product will either be repaired, renished or replaced, at
the sole discretion of Santec. Santec reserves the right to examine any product claimed
defective prior to any warranty claim being accepted or processed, at its sole discretion. This
warranty gives you specic legal rights and you may have other rights which may vary from state
to state.
03
Effective 01/01/09 - Replaces and supersedes any previously issued warranty
FINISH CARE INFORMATION
For clear coated or enamel color nishes:
We recommend that all faucets, drains, etc
be gently wiped dry with a soft cloth after use
to avoid water spotting and water deposit
buildup. A mild liquid hand soap, such as
Ivory may be used occasionally if desired.
Use of non-abrasive carnauba wax will add
protection to the nish and should be used if
the faucets will not be dried after use.
For non-clear coated and specialty nishes:
We recommend that all faucets, drains, etc be
gently wiped dry with a soft cloth after use to
avoid water spotting and water deposit
buildup. Use of a non-abrasive carnauba wax
is required occasionally.
PLEASE REGISTER YOUR PRODUCT ONLINE FOR WARRANTY SERVICES
www.santecfaucet.com/registration
04
Loading...