Santec 6656BO-TM User Manual
ESTATE SERIES BRAVO/MAGGIO COLLECTION
SANTEC
SANTEC
SANTEC
SANTEC
ROMAN TUB HAND HELD SHOWER TRIM
WITH “BO” HANDLES
MODEL: 6656AR10-TM
6656AR75-TM
Hand Held Shower Trim
1. Rough Installation
MAKE SURE THE ROUGH-IN IS PROPERLY INSTALLED FOR THE ROMAN TUB FILLER (P0385) AND
HAND HELD SHOWER (P0388). DO NOT REMOVE THE PROTECTIVE CAPS PRIOR TO TRIM
INSTALLATION.
Hot
Valve
Hot Water
Supply
P0385
Supply
SANTEC
Cold
Valve
From Diverter
to Hand Shower
FROM COLD VALVE TO DIVERTER
FROM DIVERTER TO SPOUT
FROM HOT VALVE TO DIVERTER
SANTEC
Cold Water
P0388
SANTEC
4-Port
Diverter
2. Roman Tub Filler Trim Installation
3
"
9
4
1
"
6
16
1
5
"
1
2
"
2
3
2
"
16
3
2
"
8
5
"
2
16
4
3
"
6
4
THIS HAND HELD SHOWER UNIT IS TO BE INSTALLED WITH THE MATCHING ROMAN TUB FILLER
TRIM UNIT. FOR THE ROMAN TUB FILLER TRIM INSTALLATION REFER TO 6650BO__-TM
INSTALLATION INSTRUCTIONS.
6650BO__-TM
SANTEC
Hot
Valve
Cold
Valve
From Diverter
to Hand Shower
4-Port
Diverter
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
Important : Please register your product online at www.santecfaucet.com within
30 days of purchase. Santec reserves the right to request additional documents
before servicing warranty requests.
01
Hot Water
Supply
Cold Water
Supply
FROM COLD VALVE TO DIVERTER
FROM DIVERTER TO SPOUT
FROM HOT VALVE TO DIVERTER
02
Hand Held Shower Trim
SANTEC
SANTEC
SANTEC
Hand Held Shower Trim
3. Installation
Slip the ange through the hose and screw it onto the
A
shower ange mount.
Take off the slip tab cap.
B
Take off the rubber band with rubber washers and red
washers. MAKE SURE THAT THE HOSE DOES NOT
FALL INTO THE FLANGE MOUNT.
Install the hand held shower unit with the rubber
washers and the red washers onto the hose.
Pull tab cap
Flange mount
Red washer
Rubber washer
Diverter
SANTEC
SANTEC
Diverter
4. Water Test & Flush the Line
After all the connections have been made, remove the spout’s aerator housing, basket, and washer.
Turn on the water on both hot and cold sides and ush the lines for 45 seconds.
Turn off the water and reinsert the washer, basket, and housing.
Turn on the water and check for leaks at all joints. If water leaks from any of the connections tighten the
connection until the leakage stops.
Hot
Valve
Cold
Valve
From Diverter
to Hand Shower
FROM COLD VALVE TO DIVERTER
FROM DIVERTER TO SPOUT
4-Port
Diverter
Screw the handle trim onto the diverter’s base ring.
C
Make sure the handle lever is aligned properly.
03
SANTEC
Diverter
Hot Water
Supply
Cold Water
Supply
LAYOUT OF COMPLETELY INSTALLED ROMAN TUB FILLER WITH HAND HELD SHOWER
04
Loading...