Santec 6634BO-TM User Manual
ESTATE SERIES BRAVO/MAGGIO COLLECTION
PRESSURE BALANCED TUB/SHOWER
TRIM WITH “BO” HANDLES
MODEL: 6634BO10-TM
6634BO75-TM
Specications
Description
This product is precision engineered to provide satisfactory performance provided it is installed and
operated in accordance with our recommendations contained in this manual. In order to fully enjoy the
comfort, safety and the reliability of your pressure balancing valve, be certain to familiarize yourself with the
contents of this manual.
Specication and Dimensions
Minimum operating pressure 20 psi
Maximum operating pressure 145 psi
Maximum test pressure 500 psi
Hot and cold water inlets ½" IPS
Shower outlet ½" IPS
Flow capacity 5 USGPM @ 50 psi
WALL LINE
½”
Min 36"
78"
(1981 mm)
11"
1
Ø2
"
2
3
"
8
8
1
"
3
2
Ø2
Ø7"
1
"
6
4
1
"
5
2
5
"
8
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
Important : Please register your product online at www.santecfaucet.com within
30 days of purchase. Santec reserves the right to request additional documents
before servicing warranty requests.
01
Finished Wall
Sleeve
Foam
strip
33"
FLOOR
LINE
Trim
plate
Plate
screws
½”
Plate
cover
Plug
Set screw
Allen
key
Handle
02
Pressure Balanced Shower
Pressure Balanced Shower
1. Trim Plate & Handle Installation
TRIM PLATE & PLATE COVER
Fit sleeve onto valve until it bottoms out.
Place foam strip around the inner edge of the shower plate.
Press the shower plate against the wall.
Screw the 2 plate screws through the plate holes and onto the
valve’s screw holes. Tighten both screws rmly.
Fit the plate cover over the sleeve and press it all the way into
the trim plate.
HANDLE
Insert the handle onto the valve stem. Turn the handle
clockwise until it reaches the end. Reposition the handle to
the desired position. The handle should be facing up at 12
o’clock position.
Using the provided Allen key, insert the set screw onto the
handle and press against the valve’s stem. Tighten it rmly.
Adjust the height of the handle if it is scraping against the
shower plate.
Insert the plug into the handle set screw hole.
-
Finished wall
Trim plate
Trim plate
Plate screws
Plug
Set screw
Sleeve
2. Tub Spout Installation
NOTE: The length of threaded pipe coming out from the nish wall should be no longer than 1/2”.
Wrap the pipe threading for the spout with Teon tape. Then thread the spout onto the pipe until it is
secured with the spout facing downward.
WARNING: Do not use excessive force when threading the spout.
Plate cover
Allen key
Handle
03
COLD
WARM
WARM ER
HOT
04
Loading...