Santec 6534VO-TM User Manual

VOGUE COLLECTION PRESSURE

BALANCED TUB/SHOWER TRIM

WITH “VO” HANDLES

MODEL: 6534VO10-TM

6534VO__-TM

INSTALLATION INSTRUCTIONS

Description

This product is precision engineered to provide satisfactory performance provided it is installed and operated in accordance with our recommendations contained in this manual. In order to fully enjoy the comfort, safety and the reliability of your pressure balancing valve, be certain to familiarize yourself with the contents of this manual.

NOTE: THIS IS A GRAVITATIONAL FLOW VALVE. TUB OUTLET TO BE UNRESTRICTED. SHOWER OUTLET TO BE MINIMUM 36” FROM VALVE CENTER.

Ø2

Specication and Dimensions

WALL LINE

Minimum operating pressure 20 psi

Maximum operating pressure 145 psi

Maximum test pressure 500 psi

Hot and cold water inlets ½" IPS

½”

Min 36"

78"

(1981 mm)

Shower outlet ½" IPS

Flow capacity 5 USGPM @ 50 PSI

33"

All Thread

FLOOR

Stem

LINE

Trim Plate

Flange Adaptor

½”

Flange Washer

Handle

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

Important : Please register your product online at www.santecfaucet.com within 30 days of purchase. Santec reserves the right to request additional documents before servicing warranty requests.

Lock Nut

Lock Plate

nished wall

INSTALLATION INSTRUCTIONS

Trim Installation

Place the shower plate on the all thread.

Thread the handle set with the washer and adapter onto all thread with the stem and mark the position.

Take off the handle assembly and cut off the excess thread and stem.

Keeping the handle set at 6 o’clock position, thread handle assembly onto all thread by using escutcheon being caution not to over tighten.

Trim Plate

All Thread

Lock Nut

Lock Plate

Stem

SANTEC LIFETIME LIMITED WARRANT Y

Finishes: Santec Polished Chrome, Polished Nickel and Satin Nickel nishes carry a Lifetime Limited warranty against manufacturing defects and tarnish to the original purchaser with the exclusion of kitchen drain assemblies which, due to the nature of their use, are not warranted. Santec recommended custom nishes carry a ten (10) years limited warranty against manufacturing defects and tarnish to the original purchaser with the exclusion of kitchen and pop-up drain assemblies which, due to the nature of their use, are not warranted. Kitchen products carry a three (3) year limited warranty.

Cartridges: Santec Cartridges carry a lifetime limited warranty against manufacturing defects for

2. the life of the product to the original purchaser.

Parts: Santec parts carry a ten (10) year limited warranty against manufacturing defects, to the original purchaser. Kitchen products carry a ve (5) year limited warranty.

Warranty exclusions and limitations: This warranty does not cover: damage due to negligence,

4. accident, abuse, improper installation, or improper maintenance such as, but not limited to: heat from soldering during installation, the use of plumbers putty, damage from tools used during installation, the use or exposure to chemicals or cleaning products either abrasive or non abrasive or the use of any cleaning tool or product other than a soft, clean cloth. Pop-up assemblies are not covered under warranty. This warranty does not cover: changes in the nish or in the product due to normal wear or aging and does not cover any products or parts which have been altered or used in a manner not typical for the product. This warranty does not cover and Santec will not be held liable for damage to products caused by the freight carrier and a claim should be made immediately to the freight carrier should this occur. This warranty does not cover any cost involved in the installation, repair, or replacement of any Santec product or part. This warranty does not cover and Santec will not be held liable for any loss, damages, or expenses, incidental or consequential whatsoever, originating from the purchase, installation, use, repair, failure, or replacement of any Santec product or part, as allowed by law. The product or components of the covered product will either be repaired, renished or replaced, at the sole discretion of Santec. Santec reserves the right to examine any product claimed defective prior to any warranty claim being accepted or processed, at its sole discretion. This warranty gives you specic legal rights and you may have other rights which may vary from state to state.

Effective 01/01/09 - Replaces and supersedes any previously issued warranty

FINISH CARE INFORMATION

For clear coated or enamel color nishes:

We recommend that all faucets, drains, etc be gently wiped dry with a soft cloth after use to avoid water spotting and water deposit buildup. A mild liquid hand soap, such as Ivory may be used occasionally if desired. Use of non-abrasive carnauba wax will add protection to the nish and should be used if the faucets will not be dried after use.

For non-clear coated and specialty nishes:

We recommend that all faucets, drains, etc be gently wiped dry with a soft cloth after use to avoid water spotting and water deposit buildup. Use of a non-abrasive carnauba wax is required occasionally.

PLEASE REGISTER YOUR PRODUCT ONLINE FOR WARRANTY SERVICE S

www.santecfaucet.com/registration