Santec 6520VO User Manual
VOGUE COLLECTION
WIDESPREAD LAVATORY SET
WITH “VO” HANDLES
MODEL: 6520VO10
6520VO__
PARTS BREAKDOWN
10
18
3
2
5
11
13
14
15
5
5
"
8
3"
3
"
16
8
1
"
4
Ø2
3
"
16
Ø2
3
"
16
6
3
"
8
Description
1
O-ring
2
Lift Rod & Lift Knob Set *
3
Tee Connector
5 Piece Mounting Hardware
4
Widespread Handle *
5
1.5 GPM Flow Restrictor
6
7
Pop Up Hardware P0202-X
Pop Up Flange * P0202-2
8
Pop Up Button & Plunger Kit * P0202-6
9
Spout Tube & Base Set *
10
16
6
3
19
1
4
7
Part #
PM-953
P0343
P0427
P0431
VO
PM-080
PS-2VO00-U-9
5
17
9
12
13
14
15
Description
1-1/2” Drop In Valve - Hot
11
12
1-1/2” Drop In Valve - Cold
Fiber Washer
13
Hexagonal Nut PM-607
14
Screw PM-617
15
Cartridge Only - Hot
16
Cartridge Only - Cold
17
Decorative Lip *
18
Set Screw PM-056
19
Part #
P0466
P0467
PM-332
P0418
P0419
PS-2VO00-U-6-00
8
7
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
Important : Please register your product online at www.santecfaucet.com within
30 days of purchase. Santec reserves the right to request additional documents
before servicing warranty requests.
01
* Please specify the nish when ordering the part.
02
SPOUT SPOUT
Flush both supply lines before installation. After ushing shut off both supply lines.
Hole size for the spout and handle trim is a minimum of 1¼” and a maximum of 1½”.
Spout Installation (1)
Remove tee connector and spout mounting hardware from spout.
Slip the lift rod and lift knob assembly into the back of the spout.
Apply a ring of silicone caulking around hole designated for spout. Do not use
plumber’s putty which can damage the nish of your faucet.
From the top of the sink or counter insert the spout’s threaded shank through the center
hole of the sink. Make sure the spout ange washer (if provided) or o-ring is properly
placed underneath the ange and snugly pressed against the sink top.
Spout Installation (2)
From below, slip notched washer and gasket over spout shank. Align notched washer
and gasket to allow lift rod to pass through. Attach wing nut and brass lock nut. Secure
spout by tightening the two screws on wing nut. Thread tee connector and washer to
spout shank and tighten to seal.
Wipe away any excess silicone from around the spout ange area.
Notched rubber washer
03
Lift rod assembly
O-Ring
Notched metal washer
Wing nut
Brass lock nut
Tee connector washer
Tee connector
Spout
Mounting
Hardware
04
Loading...