Santec 6120EY User Manual

PLEASE
BEFORE BEGINNING THE INSTALLATION.

READ THE INSTRUCTIONS COMPLETELY * HERITAGE

Note: Important notice on Page 3!
Read carefully installation instruction step 4!

COLLECTION

WIDESPREADS

This is a general installation instruction
For

the following collections:

MINIMUM HOLE SIZE FOR THE SPOT AND
HANDLE TRIM IS 1 ¼” AND MAXIMUM 1 ½”

DO

NOT TIGHTEN HOSE

DO NOT TIGHTEN HOSE

*** NOTE: SHUT OFF WATER SUPPLY BEFORE BEGINNING INSTALLATION***

INSPECTED BY ____________

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

Page 01

INSTALLATION INSTRUCTIONS

SPOUT INSTALLATION

COLLECTION

WIDESPREADS

Step 1.

• Remove the mounting hardware from the spout.

mounting
hardware

Step 2.

• Apply a ring of silicone caulking around hole
designated for spout.

DO NOT USE PLUMBERS’ PUTTY WHICH CAN

DAMAGE

FINISH.

• Insert spout through center hole sink or countertop.

E

N

O

C

I

L

I

S

Step 3.

• From below, slip notched washer and gasket over
spout shank. Align notched washer and gasket to
allow pop-up rod to pass through.

• Attach wing nut and brass lock nut.

wa

sher

gas

ket

wing nut

ock nut

brass l

Step 4

.

• Secure spout by tightening the two screws on wing
.

nut

• Thread tee connector and washer to spout shank

and tighten to seal

.

Tee connector & washer

Page 02