Santec 4460CO User Manual

COLOGNE COLLECTION
30” TOWEL BAR

ITEM NUMBER

4460CO _ _-_ _

30”

when Assembled

30” TOWEL BAR

LEFT BAR POST

ALLEN KEY

RIGHT BAR POST

DRYWALL SCREW, MOUNTING PACK (4)

BACK PLATE (2)

PLUG (4)

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

1- Take the trim parts off the box.
Place the trim parts against the assigned wall location.
Make sure that the bar is leveled and the bar post positions are correct.
Mark the bar post flange positions and remove the trims.

4460CO _ _

WALL

2- Using the mounting hardware post as reference, mark the screw hole positions
in the center of the post flange mark on the wall.

2a- INSTALLING ON WOODEN SURFACE

- For wooden surface, the mounting hardware posts can be secured by
screwing the screws directly into the wall.

2b- IF INSTALLING ON A DRYWALL

- Using a drill, pre-drill holes for the toggles.

- Insert the plugs into the wall.

- The mounting hardware posts can be secured by screwing the screws
into the plugs.

2c- IF INSTALLING ON A SOLID/HARD SURFACE

- Measure the dimensions carefully.

- Using a drill, pre-drill the holes.

- Secure the mounting hardware posts by screwing the screws into
the wall.

3- Using the Allen key provided, loosen the bar posts’ set screws
Slip the left bar post with the washer onto the left mounting hardware post.
Align the bar post and secure it by tightening the set screw.

WOODEN SURFACE

DRY WALL SURFACE

HARD SURFACE

4- Insert the towel bar onto the secured bar post.
Slip the right bar post with the washer onto the right mounting hardware post.
Insert the right side of the towel bar into the right bar post.
Align the right bar post and tighten the set screw firmly.

5- Check both handle posts to make sure they are firmly secured.
If not, tighten the set screws with the Allen key.

Santec Inc.

3501 Challenger Street, Torrance, CA 90503
Tel: [phone] Fax [phone]
www.santecfaucet.com

07/06

PAGE 02