Santec 4456CO User Manual

ITEM NUMBER

4456CO _ _-TM

COLOGNE COLLECTION
ROMAN TUB HANDHELD SHOWER TRIM - “CO” HANDLES

44

33

11

1010

55

66

22

77

88

##

Complete Handheld Shower Assembly *

1

Complete CO Lever Handle

2

Guide Tube *

3

Hand Shower Flange and

4

Flange Washer

5

Hexagonal Nut

6

Red Fiber Washer

7

Complete Diverter

8

Hand Shower Hose

9

Hand Shower Mounting Hardware

10

* Please specify the finish when ordering the part.

PART

DESCRIPTION

Assembly *

Washer *

HS-600/HS-700

PART #

Z-200-5

Z-200-2

Z-200-1

PM-400

PM-341

PM-332

P0500R2

PM-Z11

99

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

4456CO _ _-TM

DIVERTER INSTALLATION

1

- Unscrew the pre-assembled diverter handle trim (2) from the diverter (12).

- Slip the diverter valve body (12) up from the bottom of the tub through the appropriate hole. From tub

Flange washer

top, screw the handle trim (2) with the flange washer (17) back onto the diverter. The
washer (17) must be gently pressed against the surface. Make sure that the handle turns
freely in both directions.

- Align the handle lever and tighten the lock nut (11) firmly.

Red Fiber Washer

Red Fiber Washer

Brass lock nut

** The spout, handle valve bodies and diverter can be connected with flex hoses (not provide by Santec) or copper pipe soldering.
Please note that when soldering connections, do not use excessive heat. Excessive heat can damage the joints increasing
probability of leakage.

HAND SHOWER INSTALLATION

1

- Slip the guide tube (15), flange (14) and the washer down from the top of the tub through
the appropriate hole. Slip the mounting hardware (13) from the bottom of the tub, first the
crimped metal washer then the brass lock nut. Tighten the lock nut firmly.

2

- Wrap Teflon seal tape around the threaded outlet end (OUT) of the diverter valve. Connect and
tighten the 1/2” female side of hose (18) onto the outlet.

- Slip the other end of the hose (3/8”) up through the guide tube (!5), connect and tighten the
hose to the hand shower unit (16).

WATER TEST

- Turn on the cold water supply.

- Use the handle from the faucet set to turn the valve on and off.

- Check for leaks. If water leaks from any of the connections merely tighten the connections
until the leak stops.

- Repeat the same procedure for the hot side

Plastic washer

Metal washer
Brass lock nut

Diverter

PAGE 02