Santec 4122MT User Manual

MODEL NUMBER

PLEASE READ THE INSTRUCTIONS COMPLETELY
BEFORE BEGINNING THE INSTALLATION.

22

4122MT10
4122MT41

4122MT23
4122MT75

ESTATE SERIES BRITANI COLLECTIONESTATE SERIES BRITANI COLLECTION

CENTERSET FAUCET WITH “MT” HANDLESCENTERSET FAUCET WITH “MT” HANDLES

##

Hot Cartridge Only

1

Cold Cartridge Only

2

Aerator Washer

3

Aerator Basket with Restrictor

4
5

Complete Pop-Up *

PART

DESCRIPTION

33

44

* Please specify the finish when ordering the part.

PART #

P0408

P0409

PM-306

PM-305

P0202

11

TOOLS THAT YOU MAY NEED

55

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTION

FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION

.

AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.

MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1 1/8 ” AND MAXIMUM OF 1 ½”

FAUCET INSTALLATION

1.

- Remove optional compression fitting mounting hardware and shank lock washer and
nuts from the centerset spout’s shanks.
Apply a ring of silicon caulking around the 3 holes on the top of the sink.
Do not use plumbers' putty which can damage the finish of the faucet.

- From the top of the deck, insert the spout's threaded shanks through the
designated holes on the sink.

2.

- Slip the shank lock nuts and washer back onto the spout. Tighten the lock nuts firmly.

- Place the pop-up lift rod with the knob through the back hole in the spout.
The lift rod will be connected to the pop-up after the trim installation is completed.

3.

- The supply lines can be connected using ½” female flexible hoses supplied
by Santec or compression fitting copper pipes. The enclosed compression fitting
mounting hardware can be used for latter option. (See diagram bellow).

4.

- After the connections have been made, turn on the water supply and check for
leakages at all joints. If water leaks from any of the connections tighten the
connection until the leakage stops.

- If no leakage, turn the handles to the full open position and let the water flush for
45 second. This can prevent damages to the ceramic cartridges caused by debris
in the supply line.

4122MT _ _

Shank lock nut washer
Shank lock nut

* Enclosed Allen Key can be used when replacing cartridges or when the handles
are required to be disassembled for maintenance.

COMPRESSION FITTING ½” FLEXIBLE HOSES

COLD SUPPLY LINEHOT SUPPLY LINE

HOT SUPPLY LINE

COLD SUPPLY LINE

PAGE 02