Santec 4066WU User Manual

ESTATE SERIES TOWER COLLECTION
ROBE HOOK

ROBE HOOK POST

MOUNTING SCREW PLATE

MODEL NUMBER

4066WU _ _

SET SCREW

MOUNTING SCREWS (2)

DRY WALL TOGGLES(2)

ALLEN KEY

INSPECTED BY

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

1- Take the hook post off the box.
Place the post against the assigned wall location.
Make sure that the hooks are leveled.
Mark the post flange position and remove the trim.

4066WU _ _

WALL

2- Using the Allen key provided, remove the mounting screw plates from
the hook posts.

Press the mounting screw plate against marked hook post position on
the wall and mark the screw hole positions.

2a- INSTALLING ON WOODEN SURFACE

- For wooden surface, the mounting screw plates can be secured by
screwing the screws directly into the wall.

2b- INSTALLING ON A DRYWALL

- Using a drill, pre-drill holes for the toggles.

- Fold the toggle’s leg and insert it into the wall.

- The mounting screw plate can be secured by screwing the screws
into the toggles.

2c- IF INSTALLING ON A SOLID/HARD SURFACE

- Measure the dimensions carefully.

- Using a drill, pre-drill the holes.

- Secure the mounting screw plate by screwing the screws into
the wall.

WOODEN SURFACE

post flange mark

mounting screw plate

DRY WALL SURFACE

HARD SURFACE

3- Press the hook post against the mounting screw plate.
Align the hook post and secure it by tightening the set screw.

4- Check the hook post to make sure it is firmly secured.
If not, tighten the set screw with the Allen key.

Santec Inc.

3501 Challenger Street, Torrance, CA 90503
Tel: [phone] Fax [phone]
www.santecfaucet.com

07/04

PAGE 02