Santec 4050PR User Manual

ESTATE SERIES TOWER COLLECTION
ROMAN TUB FILLER WITH “PL” HANDLES

MODEL NUMBER

4050PR _ _

##

Complete Spout Assembly *

1

Aerator Washer

2

11

1818

1414

1515

1616

22

33

44

55

1313

66

77

55

66

77

Roman Tub Aerator without Restrictor

3

Aerator Housing *

4
5

Complete PR Lever Handle

Handle Top Lock Nut

6

7

Flange Rubber Washer

Hot Cartridge

8

9

Cold Cartridge

Valve Body Mounting Hardware

10

Complete Hot Valve

11
12

Complete Cold Valve
Quick Connect Spout Shank & Hardware

13

Set Screw

14

Spout Plug

15
16

Allen Key for Roman Tub Spout *

Tee Connector

17

O-ring for the spout plug

18

All Thread

19

* Please specify the finish when ordering the part.

PART

DESCRIPTION

Assembly *

PART #

PS-5T00S

PM-356

PM-355

P0943-U

00PR

PM-107

PM-400

P0420-SH

P0420-SC

P0495

P0496

KQ-5000S

PM-039

P0-257

P0255L

P0340

PM-445

P0341

99

1010

1212

1111

88

1010

1919

1919

1717

INSPECTED BY

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION

AFTER FLUSHING, SHUT OFF BOTH SUPPLY LINES

MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1 1/4” AND MAXIMUM IS 1 1/2”

SPOUT INSTALLATION

DO NOT REMOVE THE SPOUT PROTECTANT HOOD PRIOR TO INSTALLATION

1

- Remove the Quick Connect Spout Shank and Mounting Hardware (13) from the box.

- Remove the mounting hardware (cramped metal washer and brass lock nut) from
the Quick Connect Shank.

- From the top of the deck, insert the quick Connect shank with the brass plate
through the assigned spout hole.

- Secure the quick connect shank by putting the washer and locknut back on the
shank.

- Tighten the lock nut firmly.

4050PL _ _

Rubber Protectant Hood

Brass plate

Metal washer
Brass lock nut

2.

- Remove the faucet from the box.

- From the top of the deck, insert the spout (1) onto the top of quick connect shank.

- Align the spout and tighten the set screw (14) with the Large Allen Key (16).

- Insert the spout plug (15) into the spout back hole.

- After the valve bodies are installed, connect the spout shank (13) to one of the
outlet port of the handle valve bodies (11) and (12) **

Note: for better installation it is advisable to place silicone caulking around all holes
on the top of the deck

.

HANDLE TRIM INSTALLATION

1.

- Unscrew both pre-assembled handle trim (5) with top lock nuts(6) and rubber
washers(7) from the valve bodies (11) and (12).

- Slip the valve bodies (11) or (12) up from the bottom of the tub through the
appropriate hole next to the spout. From tub top, insert the rubber washers (7) and
screw the top lock nuts (6) and the handle trim (5) back onto the valve bodies.

- Make sure that each handle turns freely in both directions. If the handle is scraping
against the stem, lower the valve body to reduce the friction.

Large Allen Key

Metal washer
Brass lock nut

Upper Lock Nut

rubber washer

Fiber Washer

Brass lock nut

PAGE 02