Santec 3620EN User Manual

PLEASE READ THE INSTRUCTIONS COMPLETELY
BEFORE BEGINNING THE INSTALLATION.

COLLECTION

WIDESPREADS

MINIMUM HOLE SIZE FOR THE SPOUT AND
HANDLE TRIM IS 1 ¼” AND MAXIMUM OF 1 ½”

DO NOT TIGHTEN
HOSE

*** NOTE: SHUT OFF WATER SUPPLY BEFORE BEGINNING INSTALLATION***

SPOUT INSTALLATION

A- Remove tee connector and mounting hardware from the spout.

Apply a ring of silicone caulking around hole designated for spout.
DO NOT USE PLUMBERS' PUTTY WHICH CAN DAMAGE FINISH.
Insert spout through center hole of sink or countertop.

-From below slip notched washer and gasket over spout shank. Align
notched washer and gasket to allow pop-up rod to pas through.
Attach wing nut and brass lock nut.
Secure spout by tightening the two screws on wing nut.
Thread tee connector and washer to pout shank and tigfhten to seal

DO NOT TIGHTEN
HOSE

Brass lock nut

Tee connector & washer

INSPECTED BY

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

HANDLE TRIM INSTALLATION

HANDLE TRIMS ARE READY FOR DROP IN INSTALLATION.
DO NOT DISASSEMBLE.

Remove the valve body mounting hardware from the valve body.
Hot valve assembly “Red” to be mounted on left.
Cold valve assembly “Blue” to be mounted on right.

-Apply a ring of silicone caulking around the handle hole on the sink
countertop.

DO NOT USE PLUMBERS' PUTTY WHICH CAN DAMAGE FINISH

Slip valve through appropriate hole in sink or countertop.
Align handle with respect to the spout and tighten valve body locknut
until secure. Aim outlet hoses towards tee connector and attach securely
to avoid leakage.

COLLECTION

WIDESPREADS

SANTEC SANTEC

rubber washer

SANTEC SANTEC

Fiber washerFiber washer

Brass lock nutBrass lock nut

POP-UP DRAIN INSTALLATION

A- Remove decorative drain flange and drain plug from pop-up assembly. Apply a ring of silicone

caulking to underside of decorative drain flange. DO NOT USE PLUMBERS’ PUTTY, WHICH CAN
DAMAGE FINISH. Insert threaded end of the assembly up from below sink. Completely thread
drain body into decorative drain flange and align with ball rod hole facing back and tighten lock
nut from below. Insert drain plug into decorative drain flange with adjustable eye-screw facing back.
Attach ball rod washer and ball rod nut to horizontal ball rod and install into drain body. Do not over
tighten, bal rod must operate freely. Slide lift rod and knob through spout and from below the lift rod
strap and tighten thumbscrew. Gently push the horizontal ball rod down to place the drain plug in the up
position. Slip one leg of ball rod clip off horizontal ball rod and insert lift rod strap, reattach leg of ball
rod clip.

- Test pop-up for smooth operation and adjust if necessary.

Drain Flange

Drain Plug

Gasket

Washer
Lock Nut

Drain Tube

Lift Rod

Thumb Screw

Lift Rod Strap

Ball Rod

Ball Rod Clip

Ball Rod Nut

Side hole

FLUSH THE LINE

After all the connections have been made from inlet supplies to angle stop, remove the aerator. Open both hot and cold valves. Slowly open angle

stop from below and flush the lines for approximately 45 seconds to clean any debris. Turn off the water and reinsert aerator.

PAGE 02