Santec 3574TX User Manual
ITEM NUMBER
3574TX _ _-_ _
MODENA BRIDGE COLLECTIONMODENA BRIDGE COLLECTION
SINGLE HOLE BAR FAUCET ASSEMBLY WITH “TX” HANDLESSINGLE HOLE BAR FAUCET ASSEMBLY WITH “TX” HANDLES
5.25”
7
10.8”
1
10
2
7.5”
10
3
5
4
2
7.2”
8
9
##
11
PARTPART
DESCRIPTIONDESCRIPTION
Complete Centerset Faucet Assembly
Complete Centerset Faucet Assembly
with ‘TX’ handles *
with ‘TX’ handles *
PART #PART #
3574TX3574TX
Complete TX Handle Assembly Complete TX Handle Assembly
22
33
6
6
Metal WasherMetal Washer
44
Rubber WasherRubber Washer
55
Lock Nut ShankLock Nut Shank
Hose with tubular endsHose with tubular ends
66
Rubber Washer for AeratorRubber Washer for Aerator
77
AeratorAerator
88
Aerator HousingAerator Housing
99
Rubber flange washerRubber flange washer
1010
* Please specify the finish when ordering the part.* Please specify the finish when ordering the part.
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
PAGE 01
PM-400PM-400
PM-894PM-894
PM-895PM-895
PM-B100GPM-B100G
PM-44DSPM-44DS
PM-510PM-510
PM-320PM-320
PO-940-UPO-940-U
PM-400PM-400
INSTALLATION INSTRUCTIONS
FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION
.
AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.
MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1 1/4” AND MAXIMUM OF 1 1/2”
SPOUT INSTALLATION
1
- Put the single hole lavatory faucet (1) aligning its hole on the top of the sink.
Apply a ring of silicon caulking around the hole on the top of the sink. Do not use
plumbers' putty which can damage the finish of the faucet.
-Assemble the handles on the faucet arms. Slide them on the cartridge shank,
till the end. Put on the set screw and tighten it firmly.
Install the aerator washer, aerator and aerator housing on the spout mouth.
3574 TX _ _
2. From the bottom of the deck, put on the rubber washer and metal washer aligning
the three holes in the spout base and groove in the washers.
-Put on the lock shank through the washer open groove to in to the spout base groove.
Tighten the lock nut firmly. Here it is mandatory to make sure that grooves in the washers
are leaving full opening space for the hoses to go into the holes in the spout base.
HOSE TRIM INSTALLATION
- Two inlet and outlet hoses are given to connect the hot and cold water inlets.
- Insert the hoses into the holes in the base of the spout. Apply a little heavy thrust to
insert them in to the cavity, as rubber o-rings make groove a little tighter.
- Screw them on, as threads inside those holes will tighten the hoses and will make the firm grip.
- Connect the other end of the hose to the supply lines of the water to cold and hot water line
respectively.
- Tighten the nuts firmly until it secures the shank body firmly.
PAGE 02
Loading...