Santec 3568TU User Manual

MODENA COLLECTION
SOAP DISH

ITEM NUMBER

3568TU _ _-_ _

6

DRY WALL TOGGLES(2)

5

MOUNTING SCREWS (2)

4

3

MOUNTING HARDWARE POST

##

Round Glass Soap Dish

1

Body Base for Soap Dish

2

Rubber Washer Flange

3

Mounting Post Assembly

4

Drywall Mounting Screw

5
6

Screw Toggle

* Please specify the finish when ordering the part.

2

PART

1

ALLEN KEY

DESCRIPTION

6 5/8”

5 ½”

SOAP DISH

PART #

PA-8591

PA-2980
PM-400

PM-980
PM-016

PM-026

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

1- Take the soap dish unit off the box.
Place the unit against the assigned wall location.
Mark the unit’s flange position and remove the trim.

3568TU _ _

2- Using the mounting hardware post as reference, mark the screw hole positions
in the center of the flange mark on the wall.

2a- INSTALLING ON WOODEN SURFACE

- For wooden surface, the mounting hardware post can be secured by
screwing the screws directly into the wall.

2b- IF INSTALLING ON DRYWALL

- Using a drill, pre-drill holes for the toggles.

- Fold the toggle’s leg and insert it into the wall.

- The mounting hardware post can be secured by screwing the screws
into the toggles.

2c- IF INSTALLING ON SOLID/HARD SURFACE

- Measure the dimension carefully.

- Using a drill, pre-drill the holes.

- Secure the mounting hardware post by screwing the screws into
the wall.

3- Using the Allen key provided, loosen the dish base’s set screw.
Slip the base onto the mounting hardware post.
Adjust the base to make sure the dish is horizontally leveled.
Tighten the set screw after the adjustment.

WOODEN SURFACE

DRY WALL SURFACE

HARD SURFACE

4- Check the unit to make sure it is firmly secured.
If not, tighten the set screw with the Allen key.

Santec Inc.

3501 Challenger Street, Torrance, CA 90503
Tel: [phone] Fax [phone]
www.santecfaucet.com

05/03

PAGE 02