Santec 3541TX User Manual

ITEM NUMBER

3541TX _ _-_ _

MODENA BRIDGE COLLECTIONMODENA BRIDGE COLLECTION

KITCHEN FAUCET ASSEMBLY (8”) WITH “TX” CROSS HANDLESKITCHEN FAUCET ASSEMBLY (8”) WITH “TX” CROSS HANDLES

8.5”

11

13.25”

6.5”

7.25”

##

11

22
33
44

2

3

4

8”

2

3

4

55

PARTPART

DESCRIPTIONDESCRIPTION

Complete Faucet Kitchen Bridge Assembly

Complete Faucet Kitchen Bridge Assembly

with ‘TX’ handles 8 inch*

with ‘TX’ handles 8 inch*

Rubber Washer - flangeRubber Washer - flange

Crimped Metal WasherCrimped Metal Washer

Lock Nut, ShankLock Nut, Shank

Inlet-Outlet HoseInlet-Outlet Hose

* Please specify the finish when ordering the part.* Please specify the finish when ordering the part.

PART #PART #

3541TX3541TX

PM-400PM-400

PM-551PM-551

PM-550PM-550

PM-402PM-402

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION

.

AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.

MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1 1/4” AND MAXIMUM OF 1 1/2”

SPOUT INSTALLATION

1

- Put the complete bridge assembly (1) aligning two holes on the top of the sink.
Apply a ring of silicon caulking around the center hole on the top of the sink. Do not use
plumbers' putty which can damage the finish of the faucet.

- From the top of the deck, insert the spout's threaded shanks through two holes of the sink,
which are 8” apart. Make sure the spout flange washer (2) is properly placed under­ neath the flange and snugly pressed against the sink top.

3541 TX _ _

HOSE TRIM INSTALLATION

1

- Two inlet and outlet hose are given to connect the hot and cold water inlets.
Put on the hose on the thread shank of the bridge. Screw on the nuts of the
hose upwards on the shank.

- Connect other end of the hose to the supply lines of the water to cold and
hot water lines respectively.

- Tighten the nuts until it secures the shank body firmly.

PAGE 02