Santec 3532TD User Manual

ITEM NUMBER

3532TD _ _-_ _

MODENA COLLECTION
PRESSURE BALANCED SHOWER SET WITH “TD” STYLE HANDLE

17½”

9¼”

88

33

6½”

22

11

6”

3 7/8”

55

77

PART

44

DESCRIPTION

PART #

P0274

P0300WD-1

P0300-M

00YY-TD

PH28050

PB-3800

PM-033

PM-400

H

C

88

##

66

Complete Shower head *

1

Shower Arm *

2

Shower Flange *

3

Complete TD Handle for Shower *

4

Shower Trim Plate *

5

Pressure Balanced Shower Valve

6

Allen Key for Set Screw

7

Rubber Washer - flange

8

* Please specify the finish when ordering the part.

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

3532TD _ _

DESCRIPTION

This product is precision engineered to provide satisfactory performance provided it is installed and operated in
accordance with our recommendations contained in this manual. In order to fully enjoy the comfort, safety and the
reliability of your pressure balancing valve, be certain to familiarize yourself with the contents of this manual.

WALL LINE

SPECIFICATIONS AND DIMENSIONS

78"

(1981 mm)

Minimum operating pressure 20 psi
Maximum operating pressure 145 psi
Maximum test pressure 500 psi
Hot and cold water inlets ½" IPS

46"

Shower outlet ½" IPS
Flow capacity 5 USGPM@ 50 psi

FLOOR

LINE

INSTALLATION

NOTE: Failure to follow these instructions may cause damage or improper operations and nullify the warranty.

ROUGH IN

- Make sure the water supplies are off.

- Remove all the trim items (plate, handle and flange) before installation.

- Secure the valve firmly against the stud. Make sure the ½" shower outlet is in the up position.

- Make sure to flush or raise grouting on the tiled wall surface.

- Adjust the All Thread depth against the Teflon Washer and Limit Stop.
Screw the All Thread against the Teflon washer until it is pressured gently against each other.

- Tighten firmly the Lock Nut against the Lock Plate.

- Position the valve using the dimension shown in the illustration B.

Finished wall adjustment : see Illustration B

center of inlet

3.25”

All Thread

Lock Nut

Lock Plate

finished wall

Stem

Trim Plate

FLANGE WASHER HANDLE FLANGE

HANDLE BELL

HANDLE

ILLUSTRATION B

PAGE 02