Santec 3527TD User Manual

ITEM NUMBER

Ø

Ø

3527TD _ _-_ _

MODENA COLLECTION
WALL MOUNT WIDESPREAD FAUCET WITH “TD” HANDLES

10”

1313

2.175”

11

3.189”

1010

3.9”

1111

5”

33

2.175”

1212

22

1313

44

55

77

77

88

##

Wall Mount Widespread Spout *

1

Complete ‘TD’ Right Handle for Shower *

2

Complete ‘TD’ Left Handle for Shower *

3
4

Complete Corner Valve - Left

Complete Corner Valve - Right

5

Regular Adaption Kit for Shower

6

7

Hot Cartridge for Left Corner Valve

8

Cold Cartridge for Right Corner Valve

Allen Key for Set Screws

9

10

Aerator Washer

11

Aerator Basket with Restrictor

Aerator Housing *

12

Rubber Washer Flange

13

* Please specify the finish when ordering the part.

PART

DESCRIPTION

6666

PART #

PS-6DX00S

00YY-T-R

00YY-T-L

SA-Corner-L

SA-Corner-R

PM-3

P0418

P0419

PM-510

PM-320

P0940-U

PM-400

99

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION

.

AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.

MINIMUM HOLE SIZE FOR THE HANDLE TRIMS IS 1 5/8” AND MAXIMUM OF 1 3/4”

INSTALLATION INSTRUCTION

3527TD _ _

INSTALLING THE VALVE WITHOUT THE TRIM

1- If the valve is installed first without the trim, please leave
2” to 2-1/8” space between the center of the inlet and the
finished wall. This will leave enough thread length to be
adjusted when the trim is installed.

WARNING: Where tile construction is planned for the
finished walls, allow for the extra thickness
dimensions when roughing in the valves.

INSTALLING THE VALVE WITH THE TRIM

1- Install the valve onto the wall with 2” space
between the center of the valve inlet and the
finished wall.
Screw the handle flange with the flange washer
onto the handle bell and tighten it firmly.

2 ½ ”~ 2 7/8”

center of IN port

FLANGE WASHER

HANDLE FLANGE

ALL THREAD

finished wall

HANDLE BELL

STEM

HANDLE

2- Screw the handle bell, flange and washer onto
the all thread, press them firmly against the wall
and mark the position. Remove the handle bell,
flange and washer and cut off the excess thread.
Reinsert the handle bell, flange and washer onto
the all thread.

ALL THREAD

STEM

PAGE 02