Santec 3524TX User Manual
ITEM NUMBER
Ø
3524TX _ _-_ _
MODENA BRIDGE COLLECTIONMODENA BRIDGE COLLECTION
4” SPREAD BRIDGE LAVATORY SET WITH “TX” STYLE HANDLES4” SPREAD BRIDGE LAVATORY SET WITH “TX” STYLE HANDLES
7.5”
6.157”
5.25”
##
11
PARTPART
DESCRIPTIONDESCRIPTION
Complete Centerset Faucet Bridge Assembly
Complete Centerset Faucet Bridge Assembly
with ‘TX’ handles 4 inch*
with ‘TX’ handles 4 inch*
PART #PART #
PS-2D00XAPS-2D00XA
Rubber Washer FlangeRubber Washer Flange
3.5”
2
1
11.406”
6.442”
2.175”
2
7.384”
22
Mounting PackMounting Pack
33
Lift and Turn Pop drain assemblyLift and Turn Pop drain assembly
44
* Please specify the finish when ordering the part.* Please specify the finish when ordering the part.
44
PM-400PM-400
PM-898PM-898
KB-252KB-252
3
4”
3
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
PAGE 01
INSTALLATION INSTRUCTIONS
FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION
.
AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.
MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1 1/4” AND MAXIMUM OF 1 1/2”
SPOUT INSTALLATION
1
- Insert the Rubber O rings in to the shank. And put the complete bridge assembly (1)
aligning two holes on the deck holes, which are 4 inches apart.
Put in the rubber washers (PM-400) in the groove provided under the flanges.
Apply a ring of silicon caulking around the center hole on the top of the sink. Do not use
plumbers' putty which can damage the finish of the faucet.
3524 TX _ _
2
- Slip the rubber washer from the mounting hardware supply onto the shank under the deck.
After that slip on metal crimped washer on the shank and lastly the brass lock nut.
- Align the spout and tighten the shank lock nuts firmly. Tighten to seal.
PAGE 02
Loading...