Santec 3522TD User Manual
ITEM NUMBER
3522TD _ _-_ _
MODENA BRIDGE COLLECTIONMODENA BRIDGE COLLECTION
BRIDGE CENTER SET FAUCET ASSEMBLY (4”) WITH PLATE “TD” HANDLESBRIDGE CENTER SET FAUCET ASSEMBLY (4”) WITH PLATE “TD” HANDLES
12.762”
6.157”
5.25”
##
4.381”
1
11
22
33
11.145”
44
55
7.123”
6.306”
66
77
88
* Please specify the finish when ordering the part.* Please specify the finish when ordering the part.
3
2
3
4
6
2
PARTPART
DESCRIPTIONDESCRIPTION
Complete Centerset Faucet Bridge Assembly
Complete Centerset Faucet Bridge Assembly
with ‘TD’ handles 4 inch*
with ‘TD’ handles 4 inch*
Rubber O RingRubber O Ring
Platfrom Center set PlatePlatfrom Center set Plate
Rubber Platfrom GasketRubber Platfrom Gasket
Mounting Hardware PackMounting Hardware Pack
Lift -KnobLift -Knob
Lift RodLift Rod
Complete Pop-Up *Complete Pop-Up *
Top view Set Plate
PART #PART #
PS-2D00XAPS-2D00XA
PM-886PM-886
PO-2602PO-2602
PM-872PM-872
PM-898PM-898
P0-2662P0-2662
PO-214PO-214
PM-202PM-202
5
7
5
88
4”
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
PAGE 01
INSTALLATION INSTRUCTIONS
FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION
.
AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.
MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1 1/4” AND MAXIMUM OF 1 1/2”
SPOUT INSTALLATION
1
- Insert the Rubber O rings in to the shank. And put the complete bridge assembly (1)
aligning two holes on the platform center set plate. Put under the platform plate a rubber platform
gasket on the top of the wash basin deck.
Apply a ring of silicon caulking around the center hole on the top of the sink. Do not use
plumbers' putty which can damage the finish of the faucet.
2
- Slip the metal washer (3) back onto the shank. First the rubber washer, then the metal
washer and lastly the brass lock nut. Tighten the lock nut firmly.
- Insert the lift rod through the concentric hole of the lift rod shank upwards to the top of the deck.
Screw the popup lift rod in to the hole in the lift knob
- Make sure the lift rod operates smoothly. Adjust it if necessary.
- Tighten to seal.
- Align the spout and tighten the shank lock nuts firmly.
3522 TD _ _
HOSE TRIM INSTALLATION
1
- Two inlet and outlet hose are given to connect the hot and cold water inlets.
Put on the hose on the thread shank of the bridge. Screw on the nuts of the
hose upwards on the shank.
- Connect other end of the hose to the supply lines of the water to cold and
hot water lines respectively.
- Tighten the nuts until it secures the shank body firmly.
PAGE 02
Loading...