Santec 2965VA User Manual

PLEASE READ THE INSTRUCTIONS COMPLETELY
BEFORE BEGINNING THE INSTALLATION.

COLLECTION

PAPER HOLDER

This is a general installation instruction
for the following collections:
* VANTAGE
* HERITAGE

LEFT ROLLER POST

ROLLERS

SPRING

MOUNTING HARDWARE POST (2)

MOUNTING SCREWS (8)

DRY WALL TOGGLES(8)

RIGHT ROLLER POST

ALLEN KEY

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

1- Take the trim parts off the box.
Place the trim parts against the assigned wall location.
Make sure that the roller is leveled and the roller post positions are correct.
Leave 5’ to 5-1/4” space between the roller posts for the rollers.
Mark the roller post flange positions and remove the trims.

2- Using the mounting hardware post as reference, mark the screw hole positions
in the center of the post flange mark on the wall.

2a- INSTALLING ON WOODEN SURFACE

- For wooden surface, the mounting hardware posts can be secured by
screwing the screws directly into the wall.

2b- IF INSTALLING ON A DRYWALL

- Using a drill, pre-drill holes for the toggles.

- Fold the toggle’s leg and insert it into the wall.

- The mounting hardware posts can be secured by screwing the screws
into the toggles.

COLLECTION

Paper Holder

5” ~ 5 1/4”

WALL

WOODEN SURFACE

DRY WALL SURFACE

2c- IF INSTALLING ON A SOLID/HARD SURFACE

- Measure the dimensions carefully.

- Using a drill, pre-drill the holes.

- Secure the mounting hardware posts by screwing the screws into
the wall.

3- Using the Allen key provided, loosen the roller posts’ set screws.
Slip the left roller post onto the left mounting hardware post
Align the roller post and secure it by tightening the set screw.

4- Insert the rollers with the spring onto the secured roller post.
Slip the right roller post onto the right mounting hardware post.
Insert the right side of the rollers into the right roller post.
Align the roller post and tighten the set screw firmly.

5- Check both roller posts to make sure they are firmly secured.
If not, tighten the set screws with the Allen key.

HARD SURFACE

Santec Inc.

3501 Challenger Street, Torrance, CA 90503
Tel: [phone] Fax [phone]
www.santecfaucet.com

11/07

PAGE 02