Santec 2929EY User Manual

PLEASE READ THE INSTRUCTIONS COMPLETELY
BEFORE BEGINNING THE INSTALLATION.

Wall Mount Rough
and Trim

*** NOTE: SHUT OFF WATER SUPPLY BEFORE BEGINNING INSTALLATION***

MINIMUM HOLE SIZE FOR THE HANDLE TRIMS IS 1 5/8” AND MAXIMUM OF 1 ¾.
PLUMBER TO FURNISH CONNECTOR TEE AND NIPPLES.
DO NOT USE PLUMBERS’ PUTTY WHICH CAN DAMAGE FINISH.”

ROUGH INSTALLATION

NOTE: Where tile construction is planned for the

finished walls, allow for the extra thickness
dimensions when roughing in the valves.

6 1/4”

ALL THREAD

STEM

finished wall

2” ~ 2 1/8”

center to finished wall

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

HANDLE TRIM INSTALLATION

HANDLE TRIM READY FOR WALL MOUNT INSTALLATION.

DO NOT DISASSEMBLE.

- Align handle with respect to the spout.

- thread handle assembly onto all-thread by using escutcheon being
cautious not to over tighten.

NOTE:
When attaching handle assembly it may be necessary to trim back
broach and all-thread to close spacing.

CHECK INSTALLATION FOR LEAKAGES PRIOR TO CLOSING ANY WALL OR DECK

PAGE 02