Santec 2920EY User Manual

COLLECTION

WIDESPREADS

This is a general installation instruction

For the following collections:
PLEASE READ THE INSTRUCTIONS COMPLETELY * VANTAGE
BEFORE BEGINNING THE INSTALLATION.

MINIMUM HOLE SIZE FOR THE SPOT AND
HANDLE TRIM IS 1 ¼” AND MAXIMUM 1 ½”

DO NOT TIGHTEN HOSE

DO NOT TIGHTEN HOSE

*** NOTE: SHUT OFF WATER SUPPLY BEFORE BEGINNING INSTALLATION***

INSPECTED BY ____________
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

Page 01

INSTALLATION INSTRUCTIONS

SPOUT INSTALLATION

Step 1.

• Remove the mounting hardware from the spout.

Step 3.

• From below, slip notched washer and gasket over
spout shank. Align notched washer and gasket to
allow pop-up rod to pass through.

• Attach wing nut and brass lock nut.

mounting
hardware

COLLECTION

WIDESPREADS

Step 2.

• Apply a ring of silicone caulking around hole
designated for spout.

DO NOT USE PLUMBERS’ PUTTY WHICH CAN

DAMAGE FINISH.

• Insert spout through center hole sink or countertop.

S

Step 4.

• Secure spout by tightening the two screws on wing
nut.

• Thread tee connector and washer to spout shank
and tighten to seal.

E

N

O

C

I

L

I

washer

gasket

wing nut

brass lock nut

Tee connector & washer

Page 02