Santec 2681EK User Manual
rubber
fastening
washer
metal
fastening
washer
fastening
nut
MINIMUM HOLE SIZE FOR THE SPOUT
IS 1-3/8" AND MAXIMUM OF 1-7/8"
PLEASE READ THE INSTRUCTIONS COMPLETELY
BEFORE BEGINNING THE INSTALLATION.
COLLECTION
EXTENDED SINGLE
CONTROL LAV SET
This is a general installation instruction
for the following collections:
* CAPRIE * MONZA
* DOME
*** NOTE: SHUT OFF WATER SUPPLY BEFORE BEGINNING INSTALLATION***
INSPECTED BY
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
PAGE 01
INSTALLATION INSTRUCTIONS
SPOUT INSTALLATION
Step 1
· Remove lock nut, metal washer
and rubber washer from mounting
rods.
Step 3
· Reinstall rubber gasket and metal
washer from below.
· Hand tighten lock nut from below
while aligning fixture.
Step 2
· Apply a ring of silicone caulking
around hole designated for spout.
DO NOT USE PLUMBERS’ PUTTY
WHICH CAN DAMAGE FINISH.
· Insert faucet assembly through
hole in sink or counter top, being
sure to center faucet in hole.
Step 4
· Secure fixture from below by using
either an adjustable wrench, basin
wrench or deep socket to the lock
nut.
· Connect fixture to water supplies.
NOTE.
Before opening supply valves, remove aerator! Slowly open water suppl ies to flush fixtur e of any debris and
reinstall aerator prior to using fixture. Debris present in the line will damage fixture and case leaking. Failur e to
flush fixture could result in possibly voiding warranty.
S
I
L
I
C
O
N
E
COLLECTION
EXTENDED SINGLE CONTROL LAV SET
rubber washer
metal washer
lock nut
PAGE 02
Loading...