Santec 2655EZ User Manual

PLEASE READ THE INSTRUCTIONS COMPLETELY BEFORE BEGINNING THE INSTALLATION.
Complete EC Lever
Complete EC Lever
Handle Assembly
Handle Assembly
COLLECTION
Roman Tub with Hand Held Shower
Complete
Complete
Spout Assembly
Spout Assembly
SANTECSANTEC
Complete
Complete
Hot Valve
Hot Valve
Quick Connect
Quick Connect
Shank & Hardware
Shank & Hardware
Allen KeyAllen Key
Hand Shower UnitHand Shower Unit
Plastic sheathPlastic sheath
Guide tubeGuide tube
Hand shower flange & washerHand shower flange & washer
Complete
Complete
Cold Valve
Cold Valve
Diverter handle trimDiverter handle trim
Diverter valveDiverter valve
Hand shower mounting hardwareHand shower mounting hardware
Hand shower hoseHand shower hose
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
PAGE 01
SPOUT INSTALLATION
FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION. AFTER FLUSHING, SHUT OFF BOTH SUPPLY LINES.
MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1-1/4” AND MAXIMUM IS 1-1/2”
1. Remove the tee connector and spout mounting hardware from quick connect shank being sure to leave on brass plate.
2. Apply a ring of silicone caulking around hole designated for spout.
DO NOT USE PLUMBERS’ PUTTY, WHICH CAN DAMAGE FINISH.
3. From the top of the deck, slip the quick connect shank through the assigned spout hole.
MAKE SURE THE FRONT SIDE OF THE QUICK CONNECT IS POSITIONED CORRECTLY!
4. Secure the quick connect shank by putting the washer and lock nut back on the shank. Tighten the lock nut firmly.
5. From the top of the deck, slip the spout with the flange and flange washer onto the quick connect shank top. Align the spout and tighten the set screw with the Allen key provided.
6. Connect the tee connector to the spout shank.
COLLECTION
S
I
L
I
C
O
N
E
FRONT HERE
INSTALLATION INSTRUCTIONS
ROMAN TUB WITH HAND HELD
PAGE 02
Loading...
+ 4 hidden pages