Santec 2650EZ User Manual

PLEASE READ THE INSTRUCTIONS COMPLETELY
BEFORE BEGINNING THE INSTALLATION.

COLLECTION

ROMAN TUBS

This is a general installation instruction
for the following collections:
* CAPRIE * VANTAGE
* DOME * HERITAGE

MINIMUM HOLE SIZE FOR THE SPOUT AND
HANDLE TRIM IS 1 ¼” AND MAXIMUM OF 1 ½”

*** NOTE: SHUT OFF WATER SUPPLY BEFORE BEGINNING INSTALLATION***

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

SPOUT INSTALLATION

FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION.
AFTER FLUSHING, SHUT OFF BOTH SUPPLY LINES.

MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1-1/4”
AND MAXIMUM IS 1-1/2”

1. Remove the tee connector and spout mounting hardware from
quick connect shank being sure to leave on brass plate.

2. Apply a ring of silicone caulking around hole designated for spout.

DO NOT USE PLUMBERS’ PUTTY, WHICH CAN DAMAGE FINISH.

3. From the top of the deck, slip the quick connect shank through
the assigned spout hole.

MAKE SURE THE FRONT SIDE OF THE QUICK CONNECT IS
POSITIONED CORRECTLY!

4. Secure the quick connect shank by putting the washer and lock nut
back on the shank. Tighten the lock nut firmly.

5. From the top of the deck, slip the spout with the flange and flange
washer onto the quick connect shank top. Align the spout and tighten
the set screw with the Allen key provided.

6. Connect the tee connector to the spout shank.

COLLECTION

S

I

L

I

C

O

N

E

FRONT HERE

INSTALLATION INSTRUCTIONS

ROMAN TUBS

PAGE 02