Santec 2519YC User Manual

ITEM NUMBER

2519YC _ _-_ _

LEAR CRYSTAL COLLECTION
2-HANDLE WALL MOUNT TUB FILLER WITH “YC” HANDLES

11

22

33

44

55

99

SANTECSANTEC

77

SANTECSANTEC

88

##

CompleteCrystal Handle for Shower *

1

Complete Wall Mount Tub Spout *

2

Aerator Washer

3

Aerator Basket

4

Aerator Housing *

5

Complete 2-Handle Shower Valve

6

7

Hot Cartridge for Shower

8

Cold Cartridge for Shower

9

Regular Adaption Kit for Shower

Allen Key

10

* Please specify the finish when ordering the part.

PART

DESCRIPTION

P0482

P0418

P0419

PM-3

PART #

00YY-YC

PS-4A00S

PM-306

PM-455

P0952-U

66

1010

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION

.

AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.

MINIMUM HOLE SIZE FOR THE HANDLE TRIMS IS 1 5/8” AND MAXIMUM OF 1 3/4”

INSTALLATION INSTRUCTION

2519YC _ _

INSTALLING THE VALVE WITHOUT THE TRIM

1- If the valve is installed first without the trim, please leave

3 1/8” - 3½”

space between the center of the inlet and the
finished wall. This will leave enough thread length to be
adjusted when the trim is installed.

WARNING: Where tile construction is planned for the
finished walls, allow for the extra thickness
dimensions when roughing in the valves.

INSTALLING THE VALVE WITH THE TRIM

1- Install the valve onto the wall with 2” space
between the center of the valve inlet and the
finished wall.
Screw the handle flange with the flange washer
onto the handle bell and tighten it firmly.

3 1/8” - 3½”

center of IN port

FLANGE WASHER

HANDLE FLANGE

ALL THREAD

finished wall

HANDLE BELL

STEM

HANDLE

2- Screw the handle bell, flange and washer onto the
all thread, press them firmly against the wall and mark
the position. Remove the handle bell, flange and
washer and cut off the excess thread.
Reinsert the handle bell, flange and washer onto the
all thread.

ALL THREAD

STEM

PAGE 02