Santec 2513XA User Manual
ITEM NUMBER
2513XA _ _-_ _
LEAR COLLECTION
3-HANDLE TUB/ SHOWER WITH “XA” HANDLES
LESS SHOWER HEAD, ARM AND FLANGE
11
11
22
1010
1111
44
SANTECSANTEC
55
66
11
##
Complete XA Handle for Shower *
1
Complete Wall Mount Tub Spout *
2
3
Hot Cartridge for Shower
4
Regular Adaption Kit for Shower
99
SANTECSANTEC
5
Diverter Cartridge
Cold Cartridge for Shower
6
Complete 3-Handle Tub Shower Valve
7
Allen Key for Set Screws
8
Aerator Washer
9
Aerator Basket without Restrictor
10
Aerator Housing *
11
* Please specify the finish when ordering the part.
PART
DESCRIPTION
PART #
00YY-XA
PS-4A00S
P0418
PM-3
P0412
P0419
P0484
PM-306
PM-455
P0952-U
33
77
88
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
PAGE 01
INSTALLATION INSTRUCTIONS
FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION
.
AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.
MINIMUM HOLE SIZE FOR THE HANDLE TRIMS IS 1 5/8” AND MAXIMUM OF 1 3/4”
INSTALLATION INSTRUCTION
2513XA _ _
INSTALLING THE VALVE WITHOUT THE TRIM
1- If the valve is installed first without the trim, please leave
2” to 2-1/8” space between the center of the valve inlet
and the finished wall. This will leave enough thread length
to be adjusted when the trim is installed.
WARNING: Where tile construction is planned for the
finished walls, allow for the extra thickness
dimensions when roughing in the valves.
INSTALLING THE VALVE WITH THE TRIM
1- Install the valve onto the wall with 2” space
between the center of the valve inlet and the
finished wall.
Screw the handle flange with the flange washer
onto the handle bell and tighten it firmly.
2” ~ 2 1/8”
center of IN port
FLANGE WASHER
HANDLE FLANGE
ALL THREAD
finished wall
HANDLE BELL
STEM
HANDLE
2- Screw the handle bell, flange and washer onto the
all thread, press them firmly against the wall and
mark the position. Remove the handle bell, flange
and washer and cut off the excess thread.
Reinsert the handle bell, flange and washer onto the
the all thread.
ALL THREAD
STEM
PAGE 02
Loading...