Santec 2511XA User Manual

LEAR COLLECTION
2-HANDLE SHOWER WITH “XA” HANDLES

LESS SHOWER HEAD, ARM AND FLANGE

ITEM NUMBER

2511XA _ _-_ _

##

Complete LA Handle for Shower *

1

Complete 2-Handle Shower Valve

2
3

11

Hot Cartridge for Shower

4

Cold Cartridge for Shower

5

Regular Adaption Kit for Shower

Allen Key for Set Screws

6

* Please specify the finish when ordering the part.

PART

DESCRIPTION

PART #

00YY-XA

P0482

P0418

P0419

PM-3

55

SANTECSANTEC

33

SANTECSANTEC

44

22

66

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION

.

AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.

MINIMUM HOLE SIZE FOR THE HANDLE TRIMS IS 1 5/8” AND MAXIMUM OF 1 3/4”

INSTALLATION INSTRUCTION

INSTALLING THE VALVE WITHOUT THE TRIM

1- If the valve is installed first without the trim, please leave
2” to 2-1/8” space between the center of the valve inlet and
the finished wall. This will leave enough thread length to be
adjusted when the trim is installed.

2511XA _ _

finished wall

ALL THREAD

STEM

WARNING: Where tile construction is planned for the
finished walls, allow for the extra thickness
dimensions when roughing in the valves.

INSTALLING THE VALVE WITH THE TRIM

1- Install the valve onto the wall with 2” space
between the center of the valve inlet and the finished
wall.
Screw the handle flange with the flange washer
onto the handle bell and tighten it firmly.

2- Screw the handle bell, flange and washer onto the all
thread, press them firmly against the wall and mark
the position. Remove the handle bell, flange and washer
and cut off the excess thread.
Reinsert the handle bell, flange and washer onto the all
thread.

2” ~ 2 1/8”

center of IN port

FLANGE WASHER

HANDLE FLANGE

HANDLE BELL

ALL THREAD

HANDLE

STEM

PAGE 02