Santec 2131JC User Manual
ITEM NUMBER
2131JC _ _-_ _
GRAND COLLECTION
PRESSURE BALANCED SHOWER WITH “JC” HANDLE
LESS SHOWER HEAD, ARM AND FLANGE
22
H
C
11
##
33
Complete JC Handle for Shower *
1
Shower Trim Plate *
2
Pressure Balanced Shower Valve
3
* Please specify the finish when ordering the part.
PART
DESCRIPTION
PART #
00YY-JC
PH29725
PB-3800
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
PAGE 01
INSTALLATION INSTRUCTIONS
2131JC _ _
DESCRIPTION
This product is precision engineered to provide satisfactory performance provided it is installed and operated in
accordance with our recommendations contained in this manual. In order to fully enjoy the comfort, safety and the
reliability of your pressure balancing valve, be certain to familiarize yourself with the contents of this manual.
WALL LINE
SPECIFICATIONS AND DIMENSIONS
78"
(1981 mm)
Minimum operating pressure 20 psi
Maximum operating pressure 145 psi
Maximum test pressure 500 psi
Hot and cold water inlets ½" IPS
46"
Shower outlet ½" IPS
Flow capacity 5 USGPM@ 50 psi
FLOOR
LINE
INSTALLATION
NOTE: Failure to follow these instructions may cause damage or improper operations and nullify the warranty.
ROUGH IN
- Make sure the water supplies are off.
- Remove all the trim items (cap, screw, handle bell, handle flange, washer and plate) before installation.
- Secure the valve firmly against the stud. Make sure the ½" shower outlet is in the up position.
- Make sure to flush or raise grouting on the tiled wall surface.
- Adjust the All Thread depth against the Teflon Washer and Limit Stop.
Screw the All Thread against the Teflon washer until it is pressured gently against each other.
- Tighten firmly the Lock Nut against the Lock Plate.
- Position the valve using the dimension shown in the illustration B.
Finished wall adjustment : see Illustration B
center of inlet
3.25”
All Thread
Lock Nut
Lock Plate
finished wall
Stem
Trim Plate
FLANGE WASHER
HANDLE FLANGE
SCREW
HANDLE BELL
CAP
ILLUSTRATION B
PAGE 02
Loading...