Santec 1750RE User Manual

ETNA COLLECTION
ROMAN TUB FILLER WITH “RE” HANDLES

11

ITEM NUMBER

1750RE _ _-_ _

88

55

33

66

22

1111

1212

1010

22

44

##

1

2
3

4
5

6

7

8

9
10
11
12

PART

Complete Spout Assembly *

Complete RE Handle

Flange Washer

Quick Connect Spout Shank & Hardware

Valve Body Mounting Hardware

Hot Cartridge

Cold Cartridge

Complete Hot Valve

Complete Cold Valve

Tee Connector

All Thread

Allen Key for Roman Tub Spout

77

DESCRIPTION

Assembly *

33

99

55

PART #

PS-5700S

00RE

PM-400

KQ-5000S

P0416-SH

P0416-SC

P0491

P0492

P0340

P0341

* Please specify the finish when ordering the part.

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION

AFTER FLUSHING, SHUT OFF BOTH SUPPLY LINES

MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1 1/4” AND MAXIMUM IS 1 1/2”

SPOUT INSTALLATION

1750RE _ _

1

- Remove the Quick Connect Spout Shank and Mounting Hardware from the box.
Remove the mounting hardware (metal washer and brass lock nut) from the Quick Connect
Shank.

- From the top of the deck, slip the quick Connect shank with the brass plate through the
assigned spout hole.

- Secure the quick connect shank by putting the washer and locknut back on the shank.
Tighten the lock nut firmly.

2.

- Remove the faucet from the box.

- From the top of the deck, slip the spout (1) onto the quick connect shank top.
Align the spout and tighten the set screw with the Allen Key (12) provided.

3

- Connect the spout shank to one of the outlet port of the handle valve bodies after
the valve is installed. **

Note: for better installation it is advisable to place silicone caulking around all holes on the top
of the deck

If the trim is ordered separately, please keep the shank protector on the quick connect shank
at all time to avoid damages to the unit.

Large Allen Key

Brass plate

Metal washer
Brass lock nut

Metal washer
Brass lock nut

HANDLE INSTALLATION

1.

- Disassemble the handle trim (2) from the valve body. First the handle cap, then the screw,
handle ring, handle bell and lastly the handle flange with the washer.

- Slip the valve body (8) or (9) up from the bottom of the tub through the appropriate hole next
to the spout. From tub top, screw the handle trim (2) back onto the valve body. The washer (3)
must be gently pressed against the surface and the handle bell should not scrape against the
handle flange. Make sure that the handle turns freely in both directions.

2

- Position the valve body side outlet towards the tee connector (10) for easier pipe connection.
Tighten fiber washer with lock nut (5) firmly. Repeat the same procedure for the opposite side.

- Connect the water supply lines to the bottom inlets of the valve bodies. **

- Connect the valve body side outlet to the tee connector (10). **

** The spout, handle valve bodies and tee connector can be connected with flex hoses (not provide by Santec) or copper pipe
soldering. Please note that when soldering connections, do not use excessive heat. Excessive heat can damage the joints
increasing possibility of leakage.

Handle Cap
Screw

Handle Ring

Handle Bell

Handle Flange
Flange washer

Fiber washer

Brass lock nut

PAGE 02