Santec 1322MD User Manual

CLASSIC COLLECTION
4” CENTERSET WITH “MD” HANDLES

ITEM NUMBER

1322MD _ _-_ _

##

Complete Centerset Spout Body *

1

2

Complete MD Handle *

Hot Cartridge Only

3

Cold Cartridge Only

4

Aerator Washer

22

SANTECSANTECSANTECSANTEC

33

55

22

44

66

11

88

77

88

5

Aerator Basket with Restrictor

6

Aerator Housing *

7

8

Shank Lock Nut

9

Compression Fitting Mounting Hardware

Lift Knob and Lift Rod *

10
11

Complete Pop-Up *

Allen Key for the Set Screws

12

* Please specify the finish when ordering the part.

1010

PART

DESCRIPTION

PART #

PS-2100S

00MD-L left
00MD-R right

P0408

P0409

PM-306
PM_305

P0952-U

P0202

99

99

1212

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

1111

PAGE 01

INSTALLATION INSTRUCTION

FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION

.

AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.

MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1 1/8 ” AND MAXIMUM OF 1 ½”

INSTALLATION

1.

- Remove optional compression fitting mounting hardware (9) and shank lock nuts(8)
from the centerset spout’s shanks.
Apply a ring of silicon caulking around the 3 holes on the top of the sink.
Do not use plumbers' putty which can damage the finish of the faucet.

- From the top of the deck, insert the spout's threaded shanks through the
designated holes on the sink.

2.

- Slip the shank lock nuts (8) back onto the spout. Tighten the lock nuts firmly.

- Place the pop-up lift rod with the knob (10) through the back hole in the spout.
The lift rod will be connected to the pop-up after the trim installation is completed.

3.

- The supply lines can be connected using ½” female flexible hoses (13) supplied
by Santec or compression fitting copper pipes. The enclosed compression fitting
mounting hardware (9) can be used for latter option. (See diagram bellow).

4.

- After the connections have been made, turn on the water supply and check for
leakages at all joints. If water leaks from any of the connections tighten the
connection until the leakage stops.

- If no leakage, turn the handles to the full open position and let the water flush for
45 second. This can prevent damages to the ceramic cartridges caused by debris
in the supply line.

1322MD _ _

Shank lock nut

* Enclosed Allen Key (12) can be used when replacing cartridges or when the handles
are required to be disassembled for maintenance.

COMPRESSION FITTING ½” FLEXIBLE HOSES

COLD SUPPLY LINEHOT SUPPLY LINE

HOT SUPPLY LINE

COLD SUPPLY LINE

PAGE 02