Santec 1132TT User Manual

ITEM NUMBER

1132TT _ _-_ _

MONARCH COLLECTION PRESSURE BALANCED SHOWER WITH “TT” HANDLE

Complete Shower head *

Shower Arm *

Shower Flange *

Complete TT Handle for Shower *

Shower Trim Plate *

Pressure Balanced Shower Valve

Allen Key for Set Screw

* Please specify the finish when ordering the part.

PART

DESCRIPTION

PART #

P0285

P0286

P0287

00YY-TT

PH29725

PB-3800

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE

PAGE 01

INSTALLATION INSTRUCTIONS

1132TT _ _

DESCRIPTION

This product is precision engineered to provide satisfactory performance provided it is installed and operated in accordance with our recommendations contained in this manual. In order to fully enjoy the comfort, safety and the reliability of your pressure balancing valve, be certain to familiarize yourself with the contents of this manual.

WALL LINE

SPECIFICATIONS AND DIMENSIONS

78"

(1981 mm)

Minimum operating pressure 20 psi Maximum operating pressure 145 psi Maximum test pressure 500 psi Hot and cold water inlets ½" IPS

46"

Shower outlet ½" IPS Flow capacity 5 USGPM@ 50 psi

FLOOR

LINE

INSTALLATION

NOTE: Failure to follow these instructions may cause damage or improper operations and nullify the warranty.

ROUGH IN

- Make sure the water supplies are off.

- Remove all the trim items (plate, handle and bell) before installation.

- Secure the valve firmly against the stud. Make sure the ½" shower outlet is in the up position.

- Make sure to flush or raise grouting on the tiled wall surface.

- Adjust the All Thread depth against the Teflon Washer and Limit Stop. Screw the All Thread against the Teflon washer until it is pressured gently against each other.

- Tighten firmly the Lock Nut against the Lock Plate.

- Position the valve using the dimension shown in the illustration B.

Finished wall adjustment : see Illustration B

center of inlet

3.25”

All Thread

Lock Nut

Lock Plate

finished wall

Stem

Trim Plate

HANDLE BELL

HANDLE

ILLUSTRATION B

PAGE 02

+ 2 hidden pages