Sankyo ICI3Q8-5293 Instruction Manual

Type Name :

Notes :

・ ・
・ ・
・ ・
・ ・
・ ・

Sym. Cha. No. Date By Appr.

Design

H.Takahashi

AMO-NP-07533-01

Det-che

Appro.

No. S39Z-032-00-02D

Custody

2008.05.16

・ ・

Type Name ・ ・

NIDEC SANKYO CORPORATION

INSTRUCTION MANUAL

Spec. No.

Distribution

No. of sheet

Revision Page

Reference Document

ICI3Q8-5293

AMO-NP-15167-01

No AMO – NP – 15167 – 01 1

/11

-----Table of Contents-----

Contents Page

1. Before Use 2

2. Important Notice 2

3. Attentions to this instruction manual and cautions 2

4. Scope 3

5. Equipment summary and functions 3

6. Unpacking 5

7. Setup 5

7.1 How to connect 5

1) Power cable (Connector) 5

2) USB Cable 6

3) Power cable (Plug) 6

Attention to the power supply 6

7.2 How to power on and off 7

1) How to turn on the power supply 7

2) How to shut off the power supply 7

7.3 How to replace a fuse 7

7.4 How to remove a jammed card 8

8. Considerations for card handling 10

9. Daily maintenance 10

10.Notes 11

No AMO – NP – 15167 – 01 2

/11

1. Before use

This operation manual is written for technical staff experienced in the general operation

of magnetic and Non-contact IC card reader/encoders. It is intended to describe the

operation of NIDEC Sankyo 's model ICI3Q8-5293.

The terminal manufacturer shall be responsible to furnish an operation manual for end

users.

2. Important Notice

Misuse or mishandling may shorten product life or cause the product to malfunction or

operate improperly.

Please read this manual thoroughly to understand proper care and operation of the

ICI3Q8-5293.

3. Attentions to this instruction manual and cautions

This equipment is packaged for use in North America. Use in other areas will necessitate

substitution of the power cord. Please check with the terminal manufacturer for an

appropriate cable if used outside North America.

1) A user may not repair this equipment. Please ask specialized service personnel for

repair.

2) Repair or service by unqualified/untrained personnel may result in damage to the

equipment or personal injury. Please refer all repair/service operations to a trained

service technician.

3) Use of third party supplied spare parts, could result in damage to equipment or

personal injury. Use only factory supplied spare parts in service of this equipment.

4) Ensure product is placed in a clean and stable location to prevent from falling or

dropping. Please hold the product by the lower case when transporting or moving.

No AMO – NP – 15167 – 01 3

/11

4. Scope

This instruction manual is to describe proper handling procedures of the magnetic and

Non-contact IC card reader/encoder, model number ICI3Q8-5293.

5. Equipment summary and functions

Magnetic card reader/encoder, (hereafter referred to as MCRW), is a terminal with

enclosure, and embedded power supply. It is configured to read and encode magnetic cards,

working through an USB connection to the main computing system (hereafter referred to

as HOST).

Firmware is installed in the onboard flash ROM (F-ROM) and downloadable by the HOST

for ease of upgrade if required.

LED

Cover screw

Equipment upper

Upper case

Front cover

Equipment side

Fig. 1 Equipment appearance

Cover screw

Card insertion gate

Lower case