Sanitaire S634 User Manual
We suggest you record the model, type and serial
service information, always refer to these numbers
when inquiring about service.
date of purchase.
Model S634
return this product to
the store. Call 1-800-800-8975*
www.sanitairevac.com for any
of the following:
accessories
Warranty Station
*En Mexico llame al (55) 5343-4384
www.sanitairevac.com
©2004 Electrolux Home Care Products Ltd. Printed in U.S.A.
..................................
2
......................................
2
Assemble
3
4-5
..........................................
5-6
....................................................
6
6
Warranty
To reduce the risk of electric shock,
this appliance
The plug will fi t in a polarized outlet only one way. If the
still does not fi t, con tact a qualifi ed electrician to install
the proper outlet. Do not change the plug in any way.
The bag may have come dislodged in shipping. Check
the bag to insure proper seating before attempting to
dust bag or the fi lters.
The cleaner is designed to pick up dirt and dust particles.
Avoid picking up hard or sharp objects with the cleaner
to avoid bag breakage, hose clogging, or possible motor
damage.
The instructions in this booklet serve as a guide to
telephone toll free:
3900 Peoria, Illinois 61612, USA.
The Sanitaire Limited Warranty for com plete service
any time. The bearings are permanently
When using an electrical appliance, basic precautions should
always be followed, including the following:
WARNING
To reduce the risk of fi re, electric shock, or injury:
Turn off the
switch and unplug the electrical cord when not in use and before
servicing.
when used by or near children.
outdoors, or dropped into water, return it to a service center
on cord, or pull cord around sharp edges or corners. Do not
surfaces.
carrying capacity.
Turn off all controls before unplugging.
the cord.
opening blocked; keep free of dust, lint, hair, and anything that
This vacuum cleaner creates suction and contains a revolving
cigarettes, matches, or hot ashes.
gasoline, or use in areas where they may be present.
3
the back side of the handle, the other handle has two snap
away from the cleaner. Align the holes, insert the 2-part bolt
C and tighten.
apply thumb pressure so fastener
snaps into position. Secure second
fastener. Repeat steps 1 and 2
to complete the assembly of the
connector, shown, is fl at on one
side and the 4 pins snap into one
side. The connector in Detail A
alignment tabs that slide into the
A
C –
Assembly Packet
Tab
SCREWS
C - 2-PART
A - CONNECTOR
To provide a good gasket seal, the bag coupling must
seat fi rmly against the motor base and not overlap the
furniture guard.
with a screwdriver.
the upper cord hook.
shown or secure the cord into the side of the upper cord
the handle is lowered for use. Wrap the cord around the cord
Guide
C–
G
Loading...