SANHO ELECTRONICS TECHNOLOGY UDMA3 User Manual
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:(1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement. The device can be
used in portable exposure condition without restriction.
Sanho Manufacturer’s Limited Liability
Sanho warrants to the end user, that this product, excluding its
content and / or software supplied with or on the product, will be
free from material defects in the manufacture, will conform to
Sanho’s published product specifications and be fit for normal
use during the Warranty Period specified below, commencing
on the date of purchase provided that the product is legally
purchased on the market.
To make a warranty claim please contact Sanho at the
telephone number below or at support@hypershop.com within
the warranty period and provide proof of purchase (showing
date and place and name of the reseller) and product name,
type and number. You may return the product after obtaining a
Return Material Authorization number and following any other
guidelines provided by our customer support. For further
information, see www.hypershop.com. Sanho may at its option
repair this product or provide you with an equivalent
replacement. Sanho will not be liable for indirect or
consequential (including loss of data) , or for damage caused
by improper use(including use with an incompatible device) and
use not in accordance with the instructions), or by improper
installation, unprofessional repair, modification or accident. This
constitutes Sanho’s entire liability, which will never exceed the
price you paid for it, plus the necessary costs you made for the
warranty claim.
Sanho products must not be used in applications where failure
could threaten injury or life, such as life support systems.
National, state and local laws may grant you other rights that
are not affected by this warranty.
Warranty Period: 1 Year
Sanho Corporation
47456 Fremont Blvd.
Fremont CA 94538, U.S.A
Tel: +1(408)737-7878
Additional terms and conditions can be found at
www.hypershop.com
Usage of this product constitute acceptance of these terms and
conditions.
Safety Operation Instructions
We recommend user to test device before first use to
familiarize with the functions and to ensure that device
functions as per published specifications.
Do not replace the internal battery in the battery
compartment. The device is installed with internal
battery that is certified safe and compatible by the
manufacturer. Replacing with incompatible battery may
result in short circuit and fire hazard. Please contact
Sanho for the battery compartment assembly
replacement instead.
Do not use the device in a moist environment and do not
handle the device if your hands are wet. If liquid enters
the device, please immediately power off the device,
remove the battery, and send it back to the dealer for
repair. Never try to use a device that has been corroded
by liquid, as it may result in short circuit and cause fire.
Carefully power off the device and remove the battery if
the device produces odd smell, extreme heat and
smoke. Handle with care, as the device may be very hot.
If you are not using the original AC charger provided,
please make sure your charger has an output up to 10W
and certified safe by your country safety commission.
The device may be hot while charging. Please charge
the device in a ventilated area.
Power off the device before opening the back cover and
installing or removing the hard drive.
Do not place the device near heavily magnetized object.
Otherwise, data may be lost.
Contents
Overview
Main Menu
1
3
Import
Import from Memory card
Import from USB Device
Import Menu
Import All
Incremental Import Defined
Set Import Destination Folder
Incremental Import
Data Verification
File Manager
Basic Operations
Copy/Paste File
Create New FOlder
Browser
Browse Photos
Decoding Raw File
Sync With External Hard Drive
Wireless File Sharing
Using WiFi File Sharing
WiFi data Sharing Status
Connecting to Existing WiFi Network
Accessing UDMA3 on mobile devices/computers
Photo Recovery
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
Settings
View Hard Drive S.M.A.R.T. Information
Formatting Hard Drive
Firmware Upgrade
Product Specifications
23
24
25
26
Overview
Card Slot Protective Cover
Reset
Button
Top
正面
CompactFlash
Power
Switch
CF Card Slot
Directional
Buttons
OK
Menu
Display
Mode
Home
Front
USB Port
Hard Drive
Indicator
Color LCD
Screen
Battery
Indicator
Back
Zoom in/
Prev. Page
3
Zoom out/
Next Page
1
Overview
SDXC
Slot B
Back
Cover
Internal
WiFi Antenna
Left Side
Right Side
DC5V
USB3.0
SDXC
Slot A
Charging
Port
Battery
Compartment
SDXC Slot A and CF card slot could not used
concurrently. The UDMA3 could only access one of
the card slot at any point of time.
SCXC Slot B could be use concurrently with the CF card
2
Main Menu
Move Up
Enter
Move Down
Import
File Manager
Sync
WiFi Share
Recover
Settings
3
Retu rn to M ain M enu b y pre ssi ng th e but ton f rom
any sc ree n.
3
Import
Import from Memroy card
CF Car d
导入照片
文件管理
文件同步
无线分享
SD
Card
Slot B
照片恢复
系统设置
3
Wrong Wa y
SDXC Card Slot A and
CF Card Slot could not
be used concurrently!
SD
Card
Slot B
导入照片
文件管理
文件同步
无线分享
照片恢复
系统设置
导入照片
文件管理
文件同步
无线分享
照片恢复
系统设置
CF Car d
3
SD
Card
Slot A
X
SD Card
Slot A
3
4
Import
Import from USB Device
USB Drive
Import
File Manager
Sync
WiFi Share
Recover
Settings
USB Card Reader
3
Import
File Manager
Sync
WiFi Share
Recover
Settings
3
5
Loading...