Sangoma B700 Installation Manual

B700 Hybrid Installation

B700 Hybrid Telephony Card

View Datasheet
Installation Manual

Overview
Hardware Installation
BRI Cable Wiring
Software Installation

Overview

Connect up to 4 ports of plus 2 ports of or FXSBRI Analog FXO
4 ports of are supported. Mix TE and NT modes, as required. Changing modes requires no jumpers—simply invert the colour-BRI
coded module

Supports , as well as other Open Source and proprietary , Switch, , and VoIP applicationsAsterisk®FreeSwitch

™

PBX IVR gateway

uses Wanpipe Driver which includes a suite of configuration, operation and debugging utilities

Hardware Installation

Compatibility Note
Sangoma Telephony cards are designed to be compatible with most commercially available motherboards.

PCI details

Autosense compatibility with 5 V and 3.3 V PCI buses
Maximum operational power for PCI: 3 W (0.6 A @ 5 V) For PCI Express: 2.5 W (0.76 A @ 3.3 V)

PCI-Express details

1 Lane PCI Express bus
Compatible with 4x, 8x and 16x slots

Faceplate

Sangoma Telephony cards ship pre-installed with 1 U faceplate, along with a 2 U faceplate as accessory.

If you have a 2 U server, the 1 U faceplate will need to be removed to install the 2 U faceplate.
If this is your case, please view the following Demo which indicates which screws to remove and how to separate the card

-> Demo

Hardware Configuration

-> NT Power Adapter "SPEC-BNPWR1" - More Info

is requiredWhen using FXS modules, an internal 12V power to A200 main board . Use 4-pin Molex power connector from server power supply

B700 BRI Termination resistors to switch between NT and TE modes

The B700 comes with termination resistors that have to be disabled (set to OFF) when running in TE mode and enabled (set to ON) when
running in NT mode.

The resistors corresponding ports 1 and 2 are closest to the PCI base.
The ON position is closer to the NT/TE modules.
The OFF position is closer to the RJ-45 connectors.