Sangean Electronics H200 User Manual
H200
GB
Version 1
GB
The Bluetooth® word mark and logos are registered trademarks owned
by Bluetooth SIG, Inc. and any use of such marks by SANGEAN
ELECTRONICS INC. is under license.
1
2
Controls
1
NFC detection tag
2
Battery status indicator
3
Call answer-hangup button/Call
indicator
4
Battery charging indicator
5
Bluetooth status indicator
6
Max volume indicator
7
Microphone
8
Powered Speaker
9
Aux in socket
10
DC In
11
Power button
12
Volume up button
13
Volume down button
14
Bluetooth button
15
Folding handle
16
Passive speaker
Charging the unit
This unit operates on a built-in Lithium-ion battery that can be recharged
either using the USB charging port or from a USB power adaptor (not
included) with a rated output of DC 5V, 1000mA.
The rst time using your H200 speaker, connect it to DC (mains) power
and fully charge the battery. When the battery is in charging mode, the
battery charging indicator light will be in solid red. After the battery is
fully charged, the red battery charging indicator will turn off.
Note:
You can begin using the speaker while charging. Please be aware that
in this case make sure the USB power source can provide 5V 1A of
electrical current. If not, it may damage the USB power source.
1. Connect the (supplied) micro USB plug to the micro USB charging
port on the left hand side of the unit.
2. Connect the (supplied) standard USB plug end of the cable to a
power USB port on a computer or other USB charging device. When
the battery is charging, the battery indicator light will be solid red. If
the indicator light fades away this indicates that the battery is fully
charged and battery charging will be stopped.
GB
3
Power on the speaker
There are two ways to power on your speaker.
● You can press and hold the Power button to turn on the speaker.
● In addition, the speaker can be powered on via NFC: Turn on the
NFC feature on your NFC-enabled device > Hold your NFC-enabled
device directly against the H200’s NFC tag for 2 seconds. Once the
speaker is powered on successfully, the speaker will make a sound to
conrm the power is on.
Note:
Some devices may ask for conrmation from the user.
Pairing and connecting a device to the speaker
Pairing and playing your Bluetooth device for the rst time
You need to pair your Bluetooth device with your H200 before you
can auto-link to play/stream Bluetooth music through your Bluetooth
speaker. Paring creates a `bond' so the two devices can recognize each
other.
1. Turn on the speaker. The Bluetooth status indicator ( ) on the
speaker will ash a fast blue to show the speaker is discoverable.
2. Activate Bluetooth on your device according to the device's user
manual to link to the speaker. Locate the Bluetooth device list and
select the device named ‘H200’. With some mobile devices (which
are equipped with earlier versions than BT2.1 Bluetooth device), you
may need to input the pass code “0000”.
3. Once connected, there will be a confirmation tone sound and the
Bluetooth icon will turn a solid blue. You can simply select and play
any music from your source device. Volume control can be adjusted
from your source device, or directly on H200. (
volume of the speaker has been reached, the indicator for ‘MAX
VOL.’ marked on the front panel will stay solid red for 2 seconds.)
4
Note:
If the maximum
Loading...