Sangean Electronics BB100 User Manual

BLUEBOX(BB‐100)









The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc.

and any use of such marks by SANGEAN ELECTRONICS INC. is under license.



Important Safety Instructions

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings

4. Follow all instructions

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in accordance

with the instructions.

8. Do not install near any heat sources such as radiators, heat

registers, stoves or other apparatus (including amplifiers) that

produce heat.

9. Do not defect the safety purpose of the polarized or grounding type

plug. A polarized plug has two blades with one wider than

the other. A grounding type plug has two blades and a third

grounding prong. The wide blade or the third prong are provided

for your safety. If the provided plug does not fit into your outlet,

consult an electrician for replacement of the obsolete outlet
– USA version only.

10. Protect the power cord from being walked on or pinched particularly

at plug, convenience receptacles, and the point where

they exit from the apparatus.

11. Only use attachments/accessories specified by the manufacturer.

12. Use only with the cart, stand, tripod, bracket, or table specified

by the manufacturer, or sold with the apparatus. When a cart is

used, use caution when moving the cart/apparatus combination

to avoid injury from tip-over.

13. Unplug this apparatus during lightning storms or when unused

for long periods of time.

14. Refer all servicing to qualified service personnel. Servicing is

required when the apparatus has been damaged in any way,

such as power-supply cord or plug is damaged, liquid has been

spilled or objects have fallen into the apparatus, the apparatus

has been exposed to rain or moisture, does not operate normally,

or has been dropped.

15. To reduce the risk of fire or electric shock, Do not expose this

appliance to Rain or Moisture.

16. The Shock Hazard Marking and Associated Graphical Symbol

is provided on the bottom panel of unit.

17. Apparatus shall not be exposed to dripping or splashing and no

objects filled with liquids, shall be placed on the apparatus.

18. For outdoors use, to avoid electric shock, use battery only during

a raining day or the weather is wet.



For United States:

Cautions to the user

The changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate

the equipment.

RF exposure statements

IMPORTANT NOTE:

To comply with the FCC RF exposure compliance requirements, the

antenna(s) used for this transmitter must be installed to provide a

separation distance of at least 20cm (8 inches) from all persons and

must not be co-located or operating in conjunction with any other

antenna or transmitter. No change to the antenna or the device is

permitted. Any change to the antenna or the device could result in

the device exceeding the RF exposure requirements and void user’s

authority to operate the device.

Note:

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guaranty that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

● Reorient or relocate the receiving antenna.

● Increase the separation between the equipment and receiver.

● Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

● Consult the dealer or an experienced radio/TV technician for help.

CAUTION: These servicing instructions are for use by qualified service

personnel only. To reduce the risk of the electric shock, do not perform

any servicing other than that contained in the operating instructions

unless you are qualified to so.

Controls